BMW F30 DPF clogged / blocked - Dismantling, cleaning, check the values ​​after this operation ISTA.

If the car starts but stops after only a few seconds, one of the problems may be the particle filter clogging, Dismantling and cleaning may be a solution but.....

[@GGG-xx8lf]

did you have to loosen up the exhaust pipe behind it. I cannot get the DPF out .

[@PKperformanceEU]

37mbar is way toooo much! My e90 325d 197hp had 4mbar backpressure on idle after 300_000km. Stil a lot but man these 2liter n47 b47 are soo restricted even if the dpf is new it still has like 10mbar pressure on idle

[@yev9210]

Thank you for the video. Can you explain how to navigate to perform this test in Ista+? I recently also cleaned my filter on 2014 328d and wonder if it was all in vain..

[@JHAMS-007-car-repair]

Watch this video th-cam.com/video/2SArn1oqaB4/w-d-xo.html

[@xxzmk]

Do you know if there is a way to tell my F30 that I totally switched my DPF to a new one so the sensor doesn't throw the error all the time of 245700 and reduce my performance ?
I haven't siwtched it yet but I can't find the option to reset the state in the BimmerLink or BimmerCode thing

[@JHAMS-007-car-repair]

Yes, a diagnosis can be made with ISTA where you can access the particle filter and reset it.

[@igortanyarascovschi1225]

thanks for your video. What did you use to clean your sensors? how it should be done? I dont want to damage them
many thanks and await your reply please

[@JHAMS-007-car-repair]

After the sensors were removed, they were cleaned with a wire brush and then washed with brake spray.
Be very careful with the electric wires so they don't break.

[@igortanyarascovschi1225]

thanks a lot...By the way when putting back do you have the torque specs for every bolt?
@@JHAMS-007-car-repair

[@igortanyarascovschi1225]

torque specs for the sensors as well when putting them back????

[@aamo10]

​@@igortanyarascovschi1225check ista. It will tell you torque specs

[@kirwanjohn101]

What did you use to clean the filter

[@JHAMS-007-car-repair]

Some services use anti-tartar solutions for bathrooms, I sent this filter to a company that deals with professional cleaning, from what I understood it was heated to 600 degrees Celsius, then the cleaning takes place with a certain substance, I don't know more, but the results are OK so far now.

[@dompowa6705]

Hello im looking to do this job to my dpf , but i see at the end of video you got doubled the value why?