never really thought of the leverage thing, next time i use an easy out imma grab a tap handle...same principle as taps and ive used em a thousand times can't believe i didnt think of it till i watched you, thanks man preciate it.
Good tips. I had some that were badly ate up. They ruined my lisle made in USA torx bit. I went to auto zone and it was made in Taiwan. It survived the worst ones and did the job with no damage to the tool. Surprised me. I'm always USA.
I’m going crazy. I’ve tried this too and the easy out is stripping thru too. I think I’m going to have to use my drummel and cut a line for a flat head. 😵💫🤬
Drilling the head off. Then make sure you verify the drill was centered in the bolt. Then drill a hole in the center and see if that will relive the pressure enough to easy out the bolt. I’ve had some that were so bad I’d have to make a new plate.
never really thought of the leverage thing, next time i use an easy out imma grab a tap handle...same principle as taps and ive used em a thousand times can't believe i didnt think of it till i watched you, thanks man preciate it.
If you have room to use then they are great. There are a lot of locations there is no room to use one.
Thank you Chad
Good tips. I had some that were badly ate up. They ruined my lisle made in USA torx bit. I went to auto zone and it was made in Taiwan. It survived the worst ones and did the job with no damage to the tool. Surprised me. I'm always USA.
Thanks for the tips and tricks itll help a ton im sure. You seem like a wise man with experience.
I’ve been rebuilding vehicles since the late 80s.
thanks chad great video..
Thank you sir you saved my day
Your welcome
Thank you!
Good video, for me the welded nuts on the back side broke😂
I’m going crazy. I’ve tried this too and the easy out is stripping thru too. I think I’m going to have to use my drummel and cut a line for a flat head. 😵💫🤬
Drilling the head off. Then make sure you verify the drill was centered in the bolt. Then drill a hole in the center and see if that will relive the pressure enough to easy out the bolt. I’ve had some that were so bad I’d have to make a new plate.
Just weld a nut to the head of the bolt.
Don't break da knees...oye...