Very helpful video, thanks for making it! You have amazing patience and skills. So nice you see your young helper sharing your interests. Easy to see the future is bright for him in whatever walk of life he chooses.
Got the same 2210. Need same fan. I also need to remove battery and cant figure out the front clip. Its got cotter pins up top but i cant figure out wht else is holding it on. Ty
I just watched a video where a guy said he cut his fan so he could slide the fan over then bolted it on, it was years ago and still going good. Its bolted on in 4 places so a cut doesn’t matter
Very helpful video, thanks for making it! You have amazing patience and skills. So nice you see your young helper sharing your interests. Easy to see the future is bright for him in whatever walk of life he chooses.
Could have done without the elevator muzac. Otherwise thanks. This is the first video I saw showing how to get to the driveshaft.
Nice video, I like your attention to detail. I just put an engine in one of these tractors today, what a bugger dealing with that driveshaft.
Good job John Deere never makes anything easy , you had a great helper small hands are handy eh
Thank you for sharing this
I can imagine putting both of those joints in a rubber wrap after greasing them thoroughly keeping all that grease inside the u joint grease bath!
Got the same 2210. Need same fan. I also need to remove battery and cant figure out the front clip. Its got cotter pins up top but i cant figure out wht else is holding it on. Ty
Hi Ty, after the clips are off, just lift. pull forward slightly to unplug the headlights. that's all I do on mine.
Thanks for sharing this video It was benefic for me. Michel from Granby, Qc.
+Michel Vachon You're welcome, I hope your tractor runs well for you now.
Thanks a lot, but that daggone music turns me away, and I need to replace the fan and grease joints on mine! I'll mute and watch...
There's got to be a better way! I wish someone made an aftermarket "split-a-part" fan that could go on in two pieces.
I just watched a video where a guy said he cut his fan so he could slide the fan over then bolted it on, it was years ago and still going good. Its bolted on in 4 places so a cut doesn’t matter
nice video what software do you convert the file with. i cannot get sound to upload with iMovie 09
I used iMovie, then saved a copy. I upload the file outside of iMovie.
Sorry, music made me leave at 5:00 mark...