How to Replace Window Regulator 2003-2010 BMW X3
ฝัง
- เผยแพร่เมื่อ 24 ส.ค. 2024
- Buy Now!
New Window Regulator from 1AAuto.com 1aau.to/ia/1AWR...
This video shows you how to replace both the window regulator and the motor on your 2003-2010 BMW X3. Most power window problems can be traced back to either the regulator or the motor that drives it. TRQ produces affordable window regulators and motors that are designed specifically to fit your vehicle!
This process should be similar on the following vehicles:
2004 BMW X3
2005 BMW X3
2006 BMW X3
2007 BMW X3
2008 BMW X3
2009 BMW X3
2010 BMW X3
Tools you will need:
• Flat Blade Screwdriver 1aau.to/oa/1AXA...
• 10mm Socket 1aau.to/oa/1AXA...
• Trim Tool Set 1aau.to/oa/1AXX...
• T25 Socket 1aau.to/oa/1AXA...
• Socket Driver
Subscribe: / @trq
Check out our playlist:
BMW X3 2003-10 1st Gen E83: • BMW X3 2004-10 1st Ge...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Great video. If you've a car with side airbags there'll be a plastic tab top left of the panel which pries out to reveal another T25 to release the panel. You'll have to release the connector from the airbag and it has a tiny latch that pulls back to release the connector. Ignition & battery off doing that.
Great video. Thank you. How do we know if it’s motor or regulator?
Would be good if you showed the regulator clip installation which magically appeared on the new track
How do you know if the motor is bad or good? My window won’t roll up with the button but I can push it up and down. Is that for sure mean it’s just the regulator?
My panel was held on by T30 screws. T25 was too small, would have deformed the screw.
Will you be able to still open the door, if the panel is not on?
NOTE ⚠️ I now have an Airbag light after disconnecting that without the battery off. Any help on how to reset Airbag now it’s reconnected?
How long should this job take?
Thanks so much
Thank you
My door screws are t-30.