David Bradley Plow adjustment

To make the plowing easer I set the plow, adding a concave to the bottom
of the plow makes it pull down to the ground, one way you can tell if the plow needs an adjustment is if you have to push down on the handles to keep it in the ground,
If the plow is pulling to the left , you may have to adjust the Youk , put a block about 3" thick under the left wheel and set the youk so that the plow is vertical.

[@johnkozero6842]

I have my father's David Bradley he bought new he had a 1 acre garden for only a 3 hp motor lots of power your David Bradley is in nice shape brings back memories

[@billywatson8931]

Having a tractor that you know the history of is rare, and one that was owned by your father priceless ,

[@cgriffin5380]

Thank you for sharing your knowledge with us. Learning is a daily thing if you pay attention.

[@billywatson8931]

Thank you, I mumble through the video, but if you use these little tractors you understand what I am talking about.

[@davbradtrac7721]

Saddle adjust is fo handle height. Adjusting for the furrow wheel is done with the 2 bolts on the roller plate on the plow!

[@billywatson8931]

Thanks, I can see where that adjustment would work, I have never tried moving the rollers.

[@ianjames5244]

How much does the plow implement weigh do you think

[@billywatson8931]

the turning plow weighs 60 lb,

[@TheCopper13661]

Have you taken the coulter apart to maintenance..mine is frozen and wont turn

[@billywatson8931]

Try the easy way first, clean the grease fitting with a wire brush and using a two hand grease gun try pumping in grease, next remove the fitting, clean out the inside, then replace the fitting with a new one and try again.
and last , clamp the disc in the vice and remove the cap with a pipe wrench , it wont be easy but it will come off, then do all your cleaning and greasing.

[@TheCopper13661]

Does it have a simple bushing inside

[@billywatson8931]

@@TheCopper13661 Yes, bushings , there are no ball bearings in the coulter.