Driveshaft Assembly And Upgraded Longer Rod Ends To Extend The Wheelbase.
ฝัง
- เผยแพร่เมื่อ 8 เม.ย. 2022
- Assembly And Phasing The Driveshafts. And Using Upgraded Longer Rod Ends To Create A Longer Wheelbase.
www.ebay.com/itm/295197089216...
.www.ebay.com/itm/115601465763...
/ @upgradedrc3697 - ยานยนต์และพาหนะ
Awesome series man!
Hi There! thanks for the Video, i purchased the 8647X, it didn't work, i think it should be the exact 8647 without "X", is there any other part number that i can use to extend my rod ends?
Thanks a lot for the support.
Rpm makes rod ends in different lengths and different colors. Check the length you need, but I have been using these long ones and they work well. Here is the link. www.amainhobbies.com/rpm-long-shank-440-rod-ends-blue-12-rpm73395/p38149
I have the same prob with axel,did you put the longer rod ends on both ends on pan hard and servo link?thanks for videos the helped a lot and I mean a lot.
Yes, I put the correct size on.
No I was asking how you did it,I have the same problem and I ordered the rod ends you recommended and going to try and fix it,first time builder.thank you
Sorry, I guess I don't understand exactly what your problem is that you were referring to in the first comment. I have a lot of videos out there and can't remember all the details on each one.
@@upgradedrc3697 your right and I'm so sorry for that,I'm building the vanquish vs4 10 and followed and used all your videos,my front axle is off center like yours was,so I ordered those Traxxas rod ends that are 3mm longer than stock,what I need to know is did you replace both ends of the panhard bar with the new Traxxas rod ends making it 6mm longer to push axle over.
No worries, I understand now. I believe I only extended the rod end on the axelside of the panhard bar, but not sure. I'm out of town today, but when I get back I will look at it and find out, then let you know. Thanks for your patience. I also extended the rear axel by 10mm. It took some modifications, but I have not made a video on it yet.