How did you go about getting the ignition system to work on the steering column? I did the swap a while back with the new edge dash. Id like to convert back to the fox dash.
I looked at some plug and play harness they were all expensive for my budget at the time. I cross referenced wiring harness for both cars. I pull all 1992 wiring out left harnesses in place for components. Took the 2003 wiring to the body harnesses. That way harness clips could match up.
I left the pats sensor in place and zip tied the key to it. I know that’s not the best way but without tuning it out of it was the easiest option. It’s hidden behind dash
How did you go about getting the ignition system to work on the steering column? I did the swap a while back with the new edge dash. Id like to convert back to the fox dash.
Because I didn't have a way to bypass the theft system I incorporated the new edge wiring and cluster to the fox dash.
I looked at some plug and play harness they were all expensive for my budget at the time. I cross referenced wiring harness for both cars. I pull all 1992 wiring out left harnesses in place for components. Took the 2003 wiring to the body harnesses. That way harness clips could match up.
I have a 86 fox body I have a 2.3 in it. I want to put a 4.6 in it give me some advice.
If your trying to go the cheapest route have a whole crashed car. To make ease of wiring I'd use the non pats ECU from crown Vic cop cars.
Where are you located? Do you have room for my mustang needs swap
I'm in middle Tennessee. Unfortunately not my wife says already too many.
How did you solve the PATS problem? Did you buy another ECU?
Thank you about a answer
I left the pats sensor in place and zip tied the key to it. I know that’s not the best way but without tuning it out of it was the easiest option. It’s hidden behind dash
The switch is all foxbody. I graphed the 2003 harness to make the pin out work.
How much would a plug and play harness cost ??
How did you get your ignition switch system going. The one on the steering column
What headers are you running in it?
I’m using the stock exhaust from the 4.6. The ideas behind it was using everything possible off the other car.
@@justfun-zf8ru I’m doing something kinda similar but with. 5.4l did you swap your brake booster for a hydro boost or did you go manual brakes?
@@Lightning__Fox I did the hydro boost system
@@Lightning__Fox if there is something specific you are looking about it I can try and take a video so you can see it.
problems THEFTH ???
Na no problems here.
What cross member did you use?
The AJE tubular k member, with the solid motor mounts. Basically went with that because of price.
Engine mounts
I used the solid engine mounts purchased with the aje k member