Fixing a JAMMED Anycubic Kobra 2 Neo

In this video, I guide you through the step-by-step process of fixing a jammed Anycubic Kobra 2 Neo 3D printer. Whether you're a beginner or an experienced maker, dealing with a jammed printer can be frustrating. I'll show you how to identify the cause of the jam, disassemble and clean the necessary parts, and get your printer back to producing high-quality prints.
If you find this video helpful, don't forget to like, comment, and subscribe for more 3D printing tutorials and tips!

[@FizzOfInsanity]

Thank you so much! I also had little plastic pieces falling out as soon as it was opened up. :D Used some compressed air to get it super cleared and back in business!

[@RoboticsMas1]

Thank you, easy to follow and worked perfectly

[@leighbradley6506]

Thank you. It was the same issue I had. With your video, I was up and running in 15 minutes. Shame Anycubic have not worked out this problem and put a video out themselves.

[@954Film]

Glad I could help!

[@mattpotochnik5124]

Thanks this was very helpful

[@Nyxius0]

I had the same issue luckily I bought some industrial tweezers for 5 bucks on amazon and I was able to wiggle out the stuck filament and it works! thank you for saving me a headache

[@954Film]

Glad to hear you got it all fixed the tweezers are a nice tool to have

[@HELLEKSONART]

Thanks!

[@HELLEKSONART]

mine happened when i let filiament run out without switching it.

[@crazy_man_thinking]

i hope that my problem. i having that problem of not printing. But thanks i didn't think of opening that part.

[@954Film]

I hope so to I have been running this printer for a few months now everyday and it’s the only problem I have run into

[@Nobby733]

Hello, I have a problem with the same printer, the automatic calibration does not want to work, I always get an abnormal calibration, do you know what the cause is?

[@954Film]

You mean you still get a failed print after doing a calibration? If that’s the case than you most likely have to raise or lower your z offset

[@JaxonSmith-dg3lp]

I had the same problem and the offset doesn’t work (at least for me). You have to adjust the sensor (orange thing next to the nozzle) because for some reason it’s off. You can do this by going to anycubics site and following the instructions of how to switch out your sensor

[@Raze_en345]

Which is better this or ender 3 base model

[@954Film]

I like this printer far more it’s faster and has less weird problems