IH Cub Cadet 149 Charging system fix is GOOD, not going to Fry the Battery!

[@Big_Johns]

That's a nice way to prove your point Ken. 🙂👍

[@almclean4835]

Well said McKlem 😁

[@Big_Johns]

🤣🤣🤣

[@KensSmallEngineRepair]

I had to after all the complaints!

[@barryewalt3250]

Great video Ken, the older machines are cool.

[@KensSmallEngineRepair]

This one is definitely a bear! Thanks for watching!

[@LewisMowersandBoats]

Never doubted you for a second Kenny 😊

[@KensSmallEngineRepair]

I have days when I doubt myself, especially around electrical issues!

[@GardenTractorBoy]

Great information to share, thanks

[@KensSmallEngineRepair]

Thanks for watching Joseph, hope all is swell

[@HobbyMotorDK]

Good one Kenny

[@boneyardgaragesmallenginer188]

👍🏻👍🏻

[@garyclifton2180]

Nice job ken

[@KensSmallEngineRepair]

Thanks for watching Gary

[@BlueberryStinkFinger62]

I would never sell my 2021 craftsman turn tight series tractor for any other brand the craftsman is the superior build in it's class

[@KensSmallEngineRepair]

An old IH Cub Cadet will pull stumps out!

[@FrankBuyers...guitarista-iu3zg]

​@@KensSmallEngineRepair mine this summer pulled a 3600 pound camper out of my driveway and back..not even a sweat

[@KensSmallEngineRepair]

They are great for moving trailers, campers, and boats. At 850 pounds they are pretty robust!

[@FrankBuyers...guitarista-iu3zg]

@@KensSmallEngineRepair 3600 pounds is a lot heavier than 850 pounds.. there are 50 variations of the K46 hydrostatic transmission not every tractor has the same K46 hydrostatic transmission..

[@KensSmallEngineRepair]

@FrankBuyers...guitarista-iu3zg the older Cub Cadets have a full differential similar to the 8-3/4 rear end in a Dodge. Very tough, used in full size Farmall tractors

[@almclean4835]

Done and dusted, next project please

[@jimbrewer2893]

Good way to put it to bed.

[@waynestefinashen239]

Good job buddy

[@haneyoakie14]

Is there a recommendation on the break-in on the rebuild engine?

[@KensSmallEngineRepair]

I run them mid throttle for about 15 minutes then work them under a load, like a deck, for 20 minutes to increase cylinder pressure and seat the rings.

[@dnrsmallenginerepair]

Good video my friend

[@rickbroerman9267]

Great video Ken! Thank you!!