I am using the same SMC3 program (mode 1) with 3 motors. Two motors work as expected, but motor 3 only turns in one direction, regardless of which side the blue target line the pot input is on. When the pot input matches the target line, the motor stops as expected. Any idea what the problem can be? While stationary,, Pin 3 (ENB Motor 1) is reading 4.5V Pin 5 (ENB Motor 2) is reading 4.5V Pin 7 (ENB Motor 3) is reading 0.4V I am not using ENA for any motors because my Cytron MD30C boards only have pins for GND, PWM, and DIR. This is set up the same way in the working motors as it is in the non-working motor.
Hola cómo estás yo tengo un simu con movimiento pero la pantalla la tengo fija osea no se mueve con el simu es mejor la imersion si amuro el monitor al simu así se mueve
Me encantaría escuchar tu versión 🍻
Muito bom, parabéns companheiro. Tem como passar os esquemas e desenhos com medidas do cockpit e o esquema dos motore. Abraços - Brasil.
Me sumo al pedido de que la cantes en español!!! 🎤🎤🎤🎤❤❤❤❤💪💪💪💪
I am using the same SMC3 program (mode 1) with 3 motors. Two motors work as expected, but motor 3 only turns in one direction, regardless of which side the blue target line the pot input is on. When the pot input matches the target line, the motor stops as expected. Any idea what the problem can be?
While stationary,,
Pin 3 (ENB Motor 1) is reading 4.5V
Pin 5 (ENB Motor 2) is reading 4.5V
Pin 7 (ENB Motor 3) is reading 0.4V
I am not using ENA for any motors because my Cytron MD30C boards only have pins for GND, PWM, and DIR. This is set up the same way in the working motors as it is in the non-working motor.
Hola cómo estás yo tengo un simu con movimiento pero la pantalla la tengo fija osea no se mueve con el simu es mejor la imersion si amuro el monitor al simu así se mueve
es mucho mas realista!
Best regards and blessings, can you help me build one? I'm not good with blueprints, could you tell me what to use?
Me ayudas ?
terrible