Two errors that I found whilst fitting. Firstly, if you fit the top slide bar from a right hinge (demonstration shows left hinge) then the countersinks are the wrong side and the mount screws are proud. Secondly the instructions state leave a 28mm gap between mounting holes (top fixing to bottom fixing). This is impossible as you will find the connector bar has no room to move. This gap is determined by the gap in the top of your door so I suggest eyeing up the gap with the connector bar in place for a better fit. You can see in the demonstration that he left too big a gap and the connector bar is on a slight slope which is better than what I did by following the instructions and not allowing hardly a gap at all.
Hello, to answer your questions, firstly the slide rail does only have countersunk holes on one side, but there is no need to flip the slide rail over, as it is just a case of moving the slide block along the rail to the other end, if fitting right hand. Also, the TS.11205 instructions have since been updated, with the measurement now being 32mm, rather than 28mm.
Two errors that I found whilst fitting. Firstly, if you fit the top slide bar from a right hinge (demonstration shows left hinge) then the countersinks are the wrong side and the mount screws are proud. Secondly the instructions state leave a 28mm gap between mounting holes (top fixing to bottom fixing). This is impossible as you will find the connector bar has no room to move. This gap is determined by the gap in the top of your door so I suggest eyeing up the gap with the connector bar in place for a better fit. You can see in the demonstration that he left too big a gap and the connector bar is on a slight slope which is better than what I did by following the instructions and not allowing hardly a gap at all.
Hello, to answer your questions, firstly the slide rail does only have countersunk holes on one side, but there is no need to flip the slide rail over, as it is just a case of moving the slide block along the rail to the other end, if fitting right hand. Also, the TS.11205 instructions have since been updated, with the measurement now being 32mm, rather than 28mm.
I want to install on the pull side, but want to install the closer on the door frame rather than on the door. Please suggest me.