Hey can you tell me where the camshaft position sensor is on these vehicles I've been told many things like it doesn't have one or that it's controlled by the ignition control module buy I bought a cam position sensor for it but have t been able to locate where it's at to replace and I have codes p0340 on my car
I've watched that video and it says right above the oil filter under the fuel rail on the valve cover but there's nothing there no wiring or even a spot for the sensor I even used Mitchell on demand and it didn't show the location of it just the cost to replace
I can do it under an hour. Intake comes off very easily, and once out the way you can view the starter and easily replace it. Other wise you’ll be under the car fighting to get the top bolt to the starter.
think you could do that bottom bolt from the top as well?
Absolutely, but it takes no time to remove the intake manifold, and you can work from up top. However I can get a better view for the camera this way.
Did that TYC last you a good time? Thinking of going with that or ac delco. But would like to save
Cool 👍👍
Hey can you tell me where the camshaft position sensor is on these vehicles I've been told many things like it doesn't have one or that it's controlled by the ignition control module buy I bought a cam position sensor for it but have t been able to locate where it's at to replace and I have codes p0340 on my car
Here is a link to a video that should help 👉🏼 th-cam.com/video/E2mqFlsc81w/w-d-xo.htmlsi=qPx6FV1AG4aAf5ns
I've watched that video and it says right above the oil filter under the fuel rail on the valve cover but there's nothing there no wiring or even a spot for the sensor I even used Mitchell on demand and it didn't show the location of it just the cost to replace
And do you have to replace the manifold gasket
Nice video⚡️ I see your on 309⚡️
Thanks 🙏🏻 You mean was, lol
8mm ground wire?....there certainly isnt any 8mm nuts holding a ground wire onto the solenoid
It looks easier this way other than the bottom
The bottom took me only 10 minutes it is lot easier from bottom
I took mine off from bottom it only took me 10 minutes
I agree, but getting a good camera angle for a how to video is easier from up top.
You should of took it off from the bottom not much work
My ground wire nut is rounded so thats where im at
About how long did this take you?
I can do it under an hour. Intake comes off very easily, and once out the way you can view the starter and easily replace it. Other wise you’ll be under the car fighting to get the top bolt to the starter.