@@rmatvmc Is the tusk (one piece) designed Axle nut superior or as committed to holding a axle fit and snug Over the oem design that uses two axle nuts as a jamb nut
Or any motor sports dealership has an oem parts finder page on their website that illustrates the break down and schematic of each sector of the bike or atv . Not hard to find . Look at the parts break down and find the parts Oem # number . Some parts have superceded numbers meaning a new updated number
Meaning does it keep the sprocket hub snug in place against the carrier and not allow for any premature loosening weather it is a month or a year of riding . I can’t see the superiority in that (single) style axle nut over the oem design jamb nuts
My collar was seized on it, i cut it off but with my new one it gas a weld line inside of it, and i cant put it on correctly, how badly do i need the collar and what exactly does it do?
Thanks for the video and my questions about the warrior. Basically the same rear end?
What is the best way to remove a stuck sprocket flange on a atv it’s a lt230s
If it's stuck on there, try some heat and let some penetrating oil soak in like Maxima MPPL or WD-40. -Charles
@@rmatvmc thanks
I have to replace my axle hub and i can’t find the correct piece online, do you have any suggestions on where to get one?
You should be able to locate it on the OEM parts finder here: www.rockymountainatvmc.com/oem-parts/Yamaha
@@rmatvmc Is the tusk
(one piece) designed Axle nut superior or as committed to holding a axle fit and snug Over the oem design that uses two axle nuts as a jamb nut
Or any motor sports dealership has an oem parts finder page on their website that illustrates the break down and schematic of each sector of the bike or atv . Not hard to find . Look at the parts break down and find the parts Oem # number . Some parts have superceded numbers meaning a new updated number
Meaning does it keep the sprocket hub snug in place against the carrier and not allow for any premature loosening weather it is a month or a year of riding . I can’t see the superiority in that (single) style axle nut over the oem design jamb nuts
Thank you so much!!!!!!!!!!!!!!!
Hi ... the shaft sem banshee I think
Thank you!!!!!
My collar was seized on it, i cut it off but with my new one it gas a weld line inside of it, and i cant put it on correctly, how badly do i need the collar and what exactly does it do?
I installed new bearings but is hard to spin the axle. Bad?
What bearing use that axle ?