TeraFlex Install: TJ BellyUp Skid Plate (4648403)

teraflex.com/tj-hd-bellyup-sk...
The BellyUp increases your ground clearance by up to 2-3/8" inches by replacing the factory skid plate with a lower-profile heavy duty skid plate. Dennis runs us through the Install.

[@teraflexsuspensions]

Thanks! Watch for more TJ videos coming in the future!

[@bclark11]

Thanks for the video! I like seeing TJ related content.

[@hunainathsystems9184]

Nice information ! My skid plate nut were spinning , I got a new set of 6 nutserts from ebay and i am good to go !

[@Flexicokerboy]

Haha did you snap the head off the bolt at

[@CnRDirt]

I already have a 1" MML on my tj, so will this skid work with it?

[@Sir_Wrecks_A_Lot]

What abou a rubicon? Will the 241 TCase fit without a body lift?

[@djidentity]

What if you already have a BL and a 1" motor mount lift in your TJ? Can you just install the bell up pan as is at this point?

[@QbsonDWZ]

And u dont clean all that rust and screw one side then another (not cross way - to be sure that is in same pos as older one)? Geez...

[@cleverj90]

Can you just add a slip yoke eliminator and cv drive shaft instead of a motor mount spacer and body lift to fix the driveline angle?

[@tannerross6015]

What if you've got a 1" body and lift the motor with 1" lift mounts? Are the blocks still required?

[@rbyronson2426]

I have a slip yoke on my 97 tj 4" suspension and 3" body and my drive shaft vibrates. And advice or help with this.

[@CnRDirt]

or would i need to take to MML off and put your spacers in

[@jlateralus21]

Why wouldn't you paint the frame before mounting? Rust is going to be a problem there.

[@teraflexsuspensions]

Sorry but you will need a body lift with that.

[@SUPERSTUD6000]

will this work with 2 inch transfer case lowering blocks?

[@4-WHEEL-DRIVE]

can i just do a slip yoke eliminator with a new cv drive shaft

[@G5questman]

I would definitely not clean and paint my frame before I put my new skid plate back up too. Made me wanna puke living in rustsylvania.