When you change an access you usually need a software update from crown. The exemption is when the access installed has the same software version as what the forklift happens to have. Tip: check that the red emergency button is not pressed by the plastic cover.
I have a crown rc truck and is giving me an error code when i turn on the ignition key re key 109 Cant get tye access 2, 3 and 7 to power up.. any thoughts
Hi Isaac, try turning the key all the way on and hold it for a few seconds. If that doesn't work put it on Tow mode pushing and pulling the connection for the brakes to pop several times then put it back on drive mode and re-key it. I hope this helps...
@@electricforklifts-upcamerica hello there, thanks for that tip. Did not work. The display will turn only few seconds and then display is off, still got power on my key switch abd my circuit board relay pops but cant get turn power on access 7, access 3 amd access 2
Where is the speaker located, one of our lifts is way to loud its almost to loud to drive jt
im getting a 307 code on my RC5500. im thinking the access 3 is bad as well thoughts?
Check voltage between +BV and BNEG power cable connections on Access 3
If 35-38 vac replace Access 3
@@forkliftiq just replaced access 3. but now when i turn the key on. the screen lights up then turns off? any ideas?
@@bretttrujillo8437 check the red emergency button it’s possibly pushed down, it sometimes gets jammed with the plastic cover up against it.
@@forkliftiq I now have a code 109 re key! How do you re key?
@@bretttrujillo1136 rekey is to turn off and back on.
I'm having a code 714 replaced access 7 after troubleshooting. But I get the same. Turns on then screen goes blank. Any help is appreciated. Thanks
When you change an access you usually need a software update from crown. The exemption is when the access installed has the same software version as what the forklift happens to have. Tip: check that the red emergency button is not pressed by the plastic cover.
@@forkliftiq ok will do. Thank you
I have a crown rc truck and is giving me an error code when i turn on the ignition key re key 109
Cant get tye access 2, 3 and 7 to power up.. any thoughts
Hi Isaac, try turning the key all the way on and hold it for a few seconds. If that doesn't work put it on Tow mode pushing and pulling the connection for the brakes to pop several times then put it back on drive mode and re-key it. I hope this helps...
@@electricforklifts-upcamerica hello there, thanks for that tip. Did not work.
The display will turn only few seconds and then display is off, still got power on my key switch abd my circuit board relay pops but cant get turn power on access 7, access 3 amd access 2
isaac ochoa I believe you will have to replace the Access 3, Flight Systems can repair it.
@@forkliftiq
Can you explain the flight systems?
You dont think that could be the access 7?
isaac ochoa ,
Flight Systems is a module repair shop here is their link.
shop.fsip.biz/en/catalog/node/products