Oxidean Marine Oxi-digger Outrigger Kit Build Series Part 1 Sponsons
ฝัง
- เผยแพร่เมื่อ 5 ก.ย. 2023
- BUILDER'S KIT OXI-DIGGER
oxideanmarine.com/products/ox...
ARTR OXI-DIGGER
oxideanmarine.com/products/ox...
RTR OXI-DIGGER oxideanmarine.com/products/co...
Thanks for Watching Ironclad Rc Tinker test and tune everything rc
Personal contact information ironcladedout@gmail.com
Thanks B! Gotta love a rigger
Love this video I’m looking forward to seeing more of your videos, it’s nice to see someone sharing their experiences with a newbie like me.
Legendary B.B!! Appreciate the effort you put into this. This will help me greatly.
Nice work! Looks like a top quality kit. When I was building airplane kits, I used a combination of 5-minute and 45-minute epoxy. For example, I would put a dab of 5-minute in the sockets and then the 45-minute in the long seam. That way, the 5-minute helps hold everything together while the rest cures. Downside is, you better be dang sure everything is squared up before the 5-minute kicks in. 😉 As you did, I’d “paint” the inside with the longer cure epoxy to protect the balsa from the fuel. In the case of boats it’s for waterproofing of course. That also tends to create a nice filet in the long seams which adds lots of strength. OK, I’m out. Gotta run some errands for the Boss!
Awesome thanks Big B!
Mini Zonda next hopefully, I’m anxious to see that boat
I like good long videos
So much more difficult compared to the zipkit 33inch rigger sponson build
Gloves!
You tell him Dr. jet. Health and safety 1st & foremost
Good morning claw I’m from Nevada I ran my M 41 this weekend and started smoking. What would cause that? I also replace the prop from to a metal prop that cause it
Your Prop may have been to large for your setup. I like to do a test run with new props, about 30 seconds to 1 minute, pull boat, and check temps. I do this anytime I try a new props
no es necesario poner tanto epoxi
😃