Measuring the Clearance of Camshaft Bearings
ฝัง
- เผยแพร่เมื่อ 3 พ.ย. 2014
- Cylinder Head Videos
- Replace a Valve Stem Seal: • Replace Valve Stem Seal
- Valve Spring Inspection: • Valve Spring Inspection
- Cylinder Head Valve Stem To Guide Clearance: • Cylinder Head Valve St...
- Check an Engine Cylinder Head and Block for Warpage • Check an Engine Cylind...
- Measuring the Camshaft Bore: • Measuring the Camshaft...
- Measuring the Clearance of Camshaft Bearings: • Measuring the Clearanc...
- Engine Measuring Camshaft Lobe Lift: • Engine Measuring Camsh...
- Adjusting Valve Lash on Cummins 5.8l Engine: • Adjusting Valve Lash ...
Engine Block Videos:
- Main Bearing Bore Check: • Main Bearing Bore Check
- How to measure the crankshaft run-out: • How to measure cranksh...
- Crankshaft Main Bearing Journal Measurements: • Crankshaft Main Bearin...
- Evaluating Piston Rings: • Evaluating Piston Rings
- Explanation of the Connecting Rod Side Clearance Measurement: • Explanation of the Con...
- Measuring Cylinder Bore Out Of Round And Taper with a Dial Bore Gauge: • Measuring Cylinder Bor... Cylinder Head Videos
- Replace a Valve Stem Seal: • Replace Valve Stem Seal
- Valve Spring Inspection: • Valve Spring Inspection
- Cylinder Head Valve Stem To Guide Clearance: • Cylinder Head Valve St...
- Check an Engine Cylinder Head and Block for Warpage • Check an Engine Cylind...
- Measuring the Camshaft Bore: • Measuring the Camshaft...
- Measuring the Clearance of Camshaft Bearings: • Measuring the Clearanc...
- Engine Measuring Camshaft Lobe Lift: • Engine Measuring Camsh...
- Adjusting Valve Lash on Cummins 5.8l Engine: • Adjusting Valve Lash ...
Engine Block Videos:
- Main Bearing Bore Check: • Main Bearing Bore Check
- How to measure the crankshaft run-out: • How to measure cranksh...
- Crankshaft Main Bearing Journal Measurements: • Crankshaft Main Bearin...
- Evaluating Piston Rings: • Evaluating Piston Rings
- Explanation of the Connecting Rod Side Clearance Measurement: • Explanation of the Con...
- Measuring Cylinder Bore Out Of Round And Taper with a Dial Bore Gauge: • Measuring Cylinder Bor... - ภาพยนตร์และแอนิเมชัน
Thanks.This was very useful for my studies.
Holy sht, I had to scroll for 10 minutes to find something about cam bearings that was some kind of cam in block bs featuring a boomer with a hammer.
Whats the bearing test tester called?
Plastigage or plastic guage
Somehow i swap the bearings now i dont know what to do can i just torque and plastigage every cap and grind if i have to??? No marks on caps
@@jeremysmith-mp7nu do the caps have an even parting line. Look at the surface of the cap that connects to the rod. Most modern connecting rods are powder forged and then cracked. Those types have an uneven surface between the rod and the cap.
hmmm.. the camshaft being so long, its bend may upset that way of estimating clearances; i would never trust it there; for ONE rod bearing yes, just not there;
a micrometer and a bore gauge, even the cheap telescopic ones,would be my choice; BUT i mostly just use my eyes:
has it been living for a few years? still polished,no scratches? OK