Volvo Penta fuel pump priming

แชร์
ฝัง
  • เผยแพร่เมื่อ 13 ก.ย. 2024
  • Watch this before you install your new Volvo Penta fuel pump it will save you from ordering another one.

ความคิดเห็น • 8

  • @undeadpower
    @undeadpower 3 ปีที่แล้ว

    Thanks buddy exactly what I needed to know!

  • @user-rr8dn5yl7d
    @user-rr8dn5yl7d 3 ปีที่แล้ว +1

    I'm trying to ferret out what I suspect is a fuel delivery issue so I watch a lot of your videos. Your content is excellent and the information you provide is extreamly valuable. I do however have a couple of suggestions. It would be very helpful if you identified the engine you're working on, instead of just calling it a Volvo Penta. Models and years obviously vary considerably. I have a 99 5.0GL and it does not have the same fuel pump setup as the engine in this video. It appears to only have only one pump and not does it have a fuel pressure regulator that I can find; I'm not a mechanic which is why I'm watching your videos for guidance. Also, please consider shooting all of your videos in landscape mode rather than portrait. Portrait is visually limiting. Thx.

  • @BradFizer
    @BradFizer หลายเดือนก่อน

    Boat runs fine but sometimes (not always) when it’s towards 1/4 tank fuel i have to give it throttle as I start it or it won’t start. Any ideas?

  • @bartoers7735
    @bartoers7735 4 หลายเดือนก่อน

    My Volvo Penta 4.3 Gxi from 2004 starts directly and runs perfectly at low speed (max 2500 to 3000 rpm)... but when I go 3500 rpm high speed he stops directly (like everything falls out). When I restart he doesn't run anymore. When I unleashed the high pressure fuel pump the fuel flow a few seconds when turning the contact key. After reinstalling the high pressure pump connection at the top and I want to start the motor runs perfect without any problem. So it means there must be falls air or mealy a electrical problem with the fuel pump a high speed... What could it be? Thank you for your advice ;-)

  • @vasiledanci8833
    @vasiledanci8833 3 ปีที่แล้ว

    Thank you

  • @fstarockaburns425
    @fstarockaburns425 2 ปีที่แล้ว

    what causes the low pressure pump to prime? alternator, oil switch? high psi primes but not low... running barebones on a engine stand, thanks

  • @SuwanneeHomestead
    @SuwanneeHomestead ปีที่แล้ว

    I only have one fuel pump. Mine is a 4.3 GL D.
    No flow at all. Checked fuses and relays. Can you hear the pump when key is turned?

  • @raylopez9153
    @raylopez9153 8 วันที่ผ่านมา

    I see this guy don't answer any people's questions for that reason 👎don't post videos if you not going to answer any questions .