Spektrum DX6 how to convert from mode 2 to mode 1 | nanoheli.net

แชร์
ฝัง
  • เผยแพร่เมื่อ 29 ก.ย. 2024
  • This video shows you how to convert your Spektrum DX6 from mode 2 to mode 1.
    Tools you will need:
    - tweezer
    - Phillips screwdriver

ความคิดเห็น • 36

  • @offshore911
    @offshore911 9 ปีที่แล้ว

    Ich finde dein Video sehr gut!! Danke dafür

  • @SharneAndrews
    @SharneAndrews 4 ปีที่แล้ว +1

    Nice clean video, as a beginner I really need a little more verbal explanation to understand which screws are doing exactly what. Appreciate the effort thou.

  • @scornedghostify
    @scornedghostify 7 ปีที่แล้ว

    How do you tell which mode to set the sticks to

    • @NANOHELInet
      @NANOHELInet  7 ปีที่แล้ว

      The mode depends on the pilot - All is possible from Mode 1 to Mode 4 - We fly Mode 1 with Throttle pulled.

  • @organgrind
    @organgrind 9 ปีที่แล้ว

    My Dx6i is NOT the same.

    • @felixgrubbe2623
      @felixgrubbe2623 8 ปีที่แล้ว

      Obviously, cause this is the newer DX6 and not the DX6i! There's a big difference and nobody talked about the DX6i here.

  • @bibleerror.commustsee3394
    @bibleerror.commustsee3394 5 ปีที่แล้ว +1

    For pity sake videos that have no audio should not be allowed on the Internet and the people who make them are PSYCHO !!!

  • @AliGbk
    @AliGbk ปีที่แล้ว

    Actually did the same as you. I noticed it can be done without opening the radio😅 juat need to pull the rubber grips off and there is holes to adjust

  • @kencroft7933
    @kencroft7933 4 ปีที่แล้ว +2

    My god what a cack-handed fellow. I wouldn't trust him with any radio of mine. And wifey wouldn't like all the scratches he must have made on the worktop.

    • @OutbackKanga
      @OutbackKanga 3 ปีที่แล้ว

      Yup a towel on the table would of stopped all that and protected the radio from scratching and sliding around :P

  • @guidojones3212
    @guidojones3212 10 ปีที่แล้ว

    Hey I just bought the remote an it seems like I have way less power when I'm using throttle is it because of the stops that are behind it?? I saw u removed them when u was switching modes,is there any programming I can do to fix that or should I remove the stops???

  • @allabouthim03
    @allabouthim03 8 ปีที่แล้ว

    I have a dx6 also. now that you've had it opened I noticed there is an antenna wire going into the little snub antenna. What is the other thing with the 2 antenna wires on it? is that telemetry?

  • @TheMasterhazard
    @TheMasterhazard 7 ปีที่แล้ว

    I have a DX6 G3, its springs are set to mode 2 but it's in mode 1
    I guess i just swap the poti and springs

  • @smallerthanagrainofsand9008
    @smallerthanagrainofsand9008 3 ปีที่แล้ว

    today's models have a back switch for this right?

  • @demiurgiac
    @demiurgiac 10 ปีที่แล้ว

    I am pretty new to all this. Great video. THANKS!

  • @fabioghiringhelli5139
    @fabioghiringhelli5139 3 ปีที่แล้ว

    Ottimo video, fatto molto bene, ho rtisolto il mio problema, grazie!

  • @ymmmmij
    @ymmmmij 8 ปีที่แล้ว

    Good Vid (tip) small neo magnet on screwdriver shaft.

  • @blickfangQ2
    @blickfangQ2 10 ปีที่แล้ว

    Isn't the mode 1, 2, 3, 4 changeable in the settings? I thought the new dx6 don't has to be manually converted?

    • @NANOHELInet
      @NANOHELInet  10 ปีที่แล้ว +2

      Did you really think over that - only the software can be changed from one mode to the other - but how will your throttle stick (hardware) move from one side to another (one side with the spring other side without)

  • @henkayelau2722
    @henkayelau2722 9 ปีที่แล้ว

    Thanks for the video. Basis the same steps, can I do the same for the DX9? I asked as there seem to be additional 'cages' to the gimbal area

    • @NANOHELInet
      @NANOHELInet  9 ปีที่แล้ว

      yes you can do the same with DX9 or DX18
      We have a changed DX9 and a DX18 too. We are flying all our TX with Mode1 and throttle reversed (We pull throttle)

  • @SebastianRentsch
    @SebastianRentsch 9 ปีที่แล้ว

    Very good video :) Thanks a lot .

  • @ajlepel7253
    @ajlepel7253 5 ปีที่แล้ว

    Excellent video....Thank you.

  • @glenkisela8550
    @glenkisela8550 9 ปีที่แล้ว

    now fly a Quad ok?

  • @heinzdieterschmitz6100
    @heinzdieterschmitz6100 10 ปีที่แล้ว

    Toll gemacht,danke

  • @Skylarkcpt
    @Skylarkcpt 8 ปีที่แล้ว

    does this have mode 4 ? i saw mode 3

    • @NANOHELInet
      @NANOHELInet  8 ปีที่แล้ว

      Yes - it has mode 1-4

    • @Skylarkcpt
      @Skylarkcpt 8 ปีที่แล้ว

      thank F*ck im a stranger person and i need mode 4 , do you know of any other transmitters with mode 4 ?

    • @NANOHELInet
      @NANOHELInet  8 ปีที่แล้ว

      Most of the Transmitter can mode 1-4 (Graupner, Futaba, Jeti)

  • @WayneCook306
    @WayneCook306 4 ปีที่แล้ว +1

    All that i can say is there is no way you would be doing mine, Talk about rough.......

  • @massieVtec
    @massieVtec 9 ปีที่แล้ว

    I accidentally swapped my sticks over in the settings (right stick is now throttle!) and I havnt a clue how to change it back. Can't fly the plane because I don't know how to change them back. Any idea how to do this? Much appreciated

    • @DevotedDiesel
      @DevotedDiesel 9 ปีที่แล้ว

      I would say Google it. It would be the quickest way (I don't know how to)

    • @NANOHELInet
      @NANOHELInet  9 ปีที่แล้ว

      Did you change the mode in the menue of your TX to mode 2?

  • @Happygirl098
    @Happygirl098 6 ปีที่แล้ว

    Good video, especially liked the no music and talking bit. All info was written into a small box on the screen when it was required. Simple and efficient.