What if you are going down a steep incline with this mod. In theory. The oil would go to the front, and the engine would starve because it draws only from the back correct?
You didn’t flare the ends to ensure fit and you also didn’t explain how long the copper pipe is in length two very important things. Please elaborate on these topics for future commenters.
Javin Villarreal I did mention in the video that you can flair, I believe it’s not necessary the one I currently run is not flaired and it works just fine. Using the housing to pinch the tube as well as jb weld it will hold just fine. It’s not under and serious tug or pull As per the length, that’s something your gonna have to do on your own I will bend this one and re instal and cut accesses off. As I stated in description if the video this is strictly how I do it, other people may prefer to do it differently, it’s up to the owner to do there informed research.
Cheap and cheesy here......1/4 in tubing is too small it will starve the motor eventually..... always put the tubing pick up to the inner part of the case and never put kinks in your tubing! too much JB Weld or RTV scraps floating around in the oil in your case is NOT good either!
I was wondering if you bent the copper tube to fit In the hole in the bottom left under the clutch plate
Your da man keep up da good work 😎👍👍🔥
What if you are going down a steep incline with this mod. In theory. The oil would go to the front, and the engine would starve because it draws only from the back correct?
Thank you for making this video! New sub here
You didn’t flare the ends to ensure fit and you also didn’t explain how long the copper pipe is in length two very important things. Please elaborate on these topics for future commenters.
Javin Villarreal I did mention in the video that you can flair, I believe it’s not necessary the one I currently run is not flaired and it works just fine. Using the housing to pinch the tube as well as jb weld it will hold just fine. It’s not under and serious tug or pull
As per the length, that’s something your gonna have to do on your own I will bend this one and re instal and cut accesses off.
As I stated in description if the video this is strictly how I do it, other people may prefer to do it differently, it’s up to the owner to do there informed research.
Javin Villarreal the Copper tube police.
🤣
Cheap and cheesy here......1/4 in tubing is too small it will starve the motor eventually.....
always put the tubing pick up to the inner part of the case and never put kinks in your tubing!
too much JB Weld or RTV scraps floating around in the oil in your case is NOT good either!