Very helpful and pretty much spot on. Dont forget to match up your numbers (holding top grey w lower white buttons will auto match in about 1.5 seconds) Before switching from side plate to front scanner. Also switching to cross slope, must match your slope numbers before switching to slope, also by holding upper grey and lower white....... matched boom, then switch
Could you make a video showing up ...setting up slope, grade,radiante and starting to grind then setting up in automatic....it seems you got lots experience...tx
Excellent question. I believe you have to do that up top. There will be a series of menu buttons (m1, m2, m3, m4) and the slope calibration should be in one of those menus (m2 I think).
Very helpful and pretty much spot on. Dont forget to match up your numbers (holding top grey w lower white buttons will auto match in about 1.5 seconds)
Before switching from side plate to front scanner. Also switching to cross slope, must match your slope numbers before switching to slope, also by holding upper grey and lower white....... matched boom, then switch
Did not know that
Thank you, been on ground on 210 for a couple years. Much rather mill than pave and people like you saved my ass when starting out
Thanks, been out of milling for three years and going back to it this season. This has been helpful.
Parabéns o vídeo ficou muito bom tirei todas as minhas dúvidas a pesar de não falar outra língua.
Could you make a video showing up ...setting up slope, grade,radiante and starting to grind then setting up in automatic....it seems you got lots experience...tx
❤
thanks for good video about level pro,,,’
Traduccion?
Is the machine up in the air when you’re zeroing it out? And do you have to have brand new teeth in order to do this?
Great video , can you please make video for slope setting ? Thank you pal
Es español traduselo
Anyone know how to zero out the ACT values on the Wirtgen slope sensor?
Excellent question. I believe you have to do that up top. There will be a series of menu buttons (m1, m2, m3, m4) and the slope calibration should be in one of those menus (m2 I think).
Very nice
I need a video for ground for beginners please
Make a video for slope please 🙏🏼
Good video! I got a problem with level pro, hope someone could help me, how can I switch from cm to inch? Thx a lot
Wertgen 100
Wirtegen w 100 f
Necesito traducción por favor en español
Hello please I need help, can contact you outside this site