@ sorry I should be more specific. This is the first video I’ve seen where you began by completing task and then introducing the video. You may have done it before but this is the first time I’ve come across it. I thought it was effective!
@AndrewEarl-n3p No, Andrew. It's the first. I'll try and mix it up a bit depending on what's happening. But you're the first to say anything. Thanks for your encouragement.
Ben, I think if it was me I'd leave the framework built, just removing one piece at a time, doing what's needed to it then putting it back in place to check the fit.
Thanks for another great video Ben. I liked the new style introduction! Looking forward to seeing how you resolve the problem you’ve discovered.
@@AndrewEarl-n3p Thanks, Andrew. I wasn't aware of doing anything different with the introduction but I'll keep it in mind.
@ sorry I should be more specific. This is the first video I’ve seen where you began by completing task and then introducing the video. You may have done it before but this is the first time I’ve come across it. I thought it was effective!
@AndrewEarl-n3p No, Andrew. It's the first. I'll try and mix it up a bit depending on what's happening. But you're the first to say anything. Thanks for your encouragement.
hey ben we have all been there there was a saying when i started my trade check check and check again when you measure.. lovely job though
Thanks for the encouragement, Prof. It's something that my wife keeps saying to me 😭
It looks like you should start dry fitting the frames before you cut the rails and panels.
Thanks, Todd. Tune in to see how things pan out.
Ben, I think if it was me I'd leave the framework built, just removing one piece at a time, doing what's needed to it then putting it back in place to check the fit.
@@jimrick52 Oh, Jim. What a good idea. That's now in the plan. Thanks.
@@benelliott8745 your very welcome Ben 👍
Is it possible to cut the panels to make two smaller panels with a middle stile? Or make a wider to or bottom stile?
@@johncoffey5919 Thanks, John. Everyone on the channel has been really helpful with suggestions.
Is there the wiggle room to make the overall size of the cupboards smaller? ❤
@@TimPiggott Afraid not, Tim. Dawn refuses to lose any space. I have to match the current sizes. I'm going to need to process more stock and recut.
Can you not remake the top and bottom wider either by replacing or glueing an extra piece on.
@@billtrossell4135 Thank you, Bill. That's something I hadn't thought about.