AgOpenGps goes Can Bus

Activation of steering via small GO button, original button or tablet. Disabling over same buttons or light turning of steering wheel. The big GO and END buttons are controlling the rear equipment, as well AgOpenGPS for marking.

[@820Connoisseur]

Sehr nice!
Will ich für meinen 820 genau so auch umsetzen. Wo bist du an den CAN-Bus gegangen? Und wie schaltest du das Relais über den CAN-Bus (s. Kommentar von dir unten)? Mit einem Arduino mit einem CAN-Modul?

[@Spinalking1]

Hallo, darf ich fragen wie du die Lenkung realisiert hast?
Ich hab einen NewHolland t6.150 mit, hydraulischer Lenkung.
Ich will nämlich keinen reibmotor installieren.
Danke!!!

[@dgb5820]

How did it go with canbus

[@richardklasens1041]

Does your autosteer button on your right also switch on/off autosteer in AOG?

[@thomasdeistler4435]

Yes

[@v12cat]

Is the Fendt steering valve and steering wheel sensor being used over can bus?

[@thomasdeistler4435]

No, both analog

[@flo__60]

@@thomasdeistler4435 where did you connect to the steering sensor data wire? the first really accessible plug is shared with the suspension height sensor so there is choice among 5 wires and I'm not to keen on playing around in this with my voltmeter!!!

[@thomasdeistler4435]

@@flo__60 why not, you could build a interface part to contact the angle signal. I connected in the cabin on the right side next to the fuses. However mine was pre-equiped.

[@flo__60]

@@thomasdeistler4435 oh that right I've read that a while back i was hoping that using AOG you still needed to connect it!!!

[@martincarroll5738]

What tablet and GPS receiver are you using Thomas? Very Impressive setup you have!

[@thomasdeistler4435]

Hi Martin, tablet is a dell venue 7140, gps receiver is a trimble bd982.

[@martincarroll5738]

@@thomasdeistler4435 Thanks Thomas.

[@wandnoah]

Geht das auch für Cerea?

[@thomasdeistler4435]

Ja klar, über den Can Bus wird nur ein Relais geschalten.

[@wandnoah]

@@thomasdeistler4435 okay, muss ich mich wohl Mal schlau machen.

[@joshobrandoemoey]

Hey there thomas! Nice videos! Nice work with controlling through the canbus. I am working on a project myself and was looking for some help. Is it possible to get in contact with you mail/whatsapp, to ask you some questions?

[@thomasdeistler4435]

Still online? :) Net seen that comment, checkout deistho on Telegram