blocked DPF/no start (cleaned out using Wynn's off car cleaner)

แชร์
ฝัง
  • เผยแพร่เมื่อ 21 ต.ค. 2024
  • Edited by VideoGuru:videoguru.page...

ความคิดเห็น • 19

  • @Russell_Duncan
    @Russell_Duncan ปีที่แล้ว +2

    Used the same product with great success for the first time a few weeks ago. I flushed it backwards similar to what you did. Had the hose running through it for hours following an overnight soak but I just couldn’t get rid of the soapy bubbles. Just had to say ‘that’s enough’ in the end and put it back on the car. Worked a treat though and cheered the customer up no end. I had warned him it was one of the worst I’d seen. It was a bit of a shot to nothing to be honest but it was very satisfying when it worked. Makes me wonder if we’ll ever find one that can’t be cleaned?

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว

      I was thinking the same thing, maybe if the internal part is deformed from overheating, although I haven't seen it happen. Cheers Matt

  • @wackey3455
    @wackey3455 ปีที่แล้ว +1

    Well done matt the dpf are very expensive luckily enough you where able to clear it for the customer. and you cant trust them second hand ones either. Good job

  • @Ianf1x
    @Ianf1x ปีที่แล้ว +1

    As you said looks like its a Good cleaner. Thanks for showing the results of this product.

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว +2

      It's a shame I didn't record the no start, thanks for watching

  • @davidbonnett5441
    @davidbonnett5441 ปีที่แล้ว

    Got one of those in my shed off a Juke. Going to try to clean out in an attempt to save the customer a bit of money as she's struggling. Fingers crossed it works 😂. Nothing to lose.

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว

      That is the same reason I tried the off car cleaner on this one, it wasn't too hard to remove it to give it a go. Thanks for watching

  • @demil3618
    @demil3618 ปีที่แล้ว

    How much would the back pressure be at max?
    You had 5bar? Sounds a bit too much.
    I‘d be guessing maybe 0.2bar max, am I close?

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว

      Yes you are correct, that would be on a running engine. This one was so blocked that it wouldn't even start. Thanks for watching

  • @johndutton2895
    @johndutton2895 ปีที่แล้ว +1

    Good job Matt 👍 have you seen oreilys autos working his magic with the launch gun, he’s getting some good results with it.

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว

      Yes, he certainly knows what he is doing. The launch product looks good, getting results with it on the car

  • @marke293
    @marke293 8 หลายเดือนก่อน

    Great helpful content Matt would a blocked DPF cause an extended crank on startup ? Thanks

    • @mechanicmatt871
      @mechanicmatt871  8 หลายเดือนก่อน +1

      I haven't had a long crank from a blocked dpf, only from bad glow plugs/air in the fuel/ bad cam sensor. Cheers Matt

  • @miladgamings.6669
    @miladgamings.6669 3 หลายเดือนก่อน

    How long you have to let wynn in it for ?

    • @mechanicmatt871
      @mechanicmatt871  3 หลายเดือนก่อน

      I left it over night then flushed it out

  • @paulmcgair5796
    @paulmcgair5796 ปีที่แล้ว +1

    Can you activate a dpf regen via the obd2 port

    • @mechanicmatt871
      @mechanicmatt871  ปีที่แล้ว

      If the car runs with no faults you can, I prefer not to do this. I don't like the engine running with a high rpm for so long when it's unloaded

  • @truth.hurts...
    @truth.hurts... 5 หลายเดือนก่อน

    Your not cleaning it right

    • @mechanicmatt871
      @mechanicmatt871  5 หลายเดือนก่อน +1

      It worked, it went from being so blocked that the car wouldn't start, to running with no blockage. I got the results I wanted. I also followed the instructions on the label on the bottle. How would you clean it out?