The way I do it is I leave the oil and coolant lines and wastegate actuators attached to the turbos but only unbolt their mount points from the engine. And I pull both turbos up and out of the engine bay all at once. Saves a lot of time.
Hey do you guys remember if you drained the low temperature coolant? Looks like you didn’t in the video but the workshop manual instructs to drain it.. how did you go about this?
Aftermarket intake in engine bay intake? So change from stock cold air intake to aftermarket hot air intake. Hot air has a lower density, so less air equals less power. The owner is an amateur!
Took about 3 hrs the first time for me. Now I can do an entire job in about 50 mins.
Nicely done!
damn bro do my install haha
The way I do it is I leave the oil and coolant lines and wastegate actuators attached to the turbos but only unbolt their mount points from the engine. And I pull both turbos up and out of the engine bay all at once. Saves a lot of time.
@@linkmistamaineventdid you have to drain any coolant?
Very good video & good comments, very interesting, thank you for doing this!
Hey do you guys remember if you drained the low temperature coolant? Looks like you didn’t in the video but the workshop manual instructs to drain it.. how did you go about this?
Looks like a fairly easy install
I always cover the car where iam.working,and alwayssssss cover all the turbo inlets/outlets when grinding.
Thanks, will do! Tho, we were grinding on the old turbos and wear scratch free clothing
How did you remove the lines that run to the bottom of the turbos? I can’t fit a tool in there for the life of me
But doesnt he need to change the clutches and spark plugs and more or was it done before it?
Is it just plug and play for the ptg1000s?
I wonder the same thing
Does it still pass emission tests or do you have to take off and install the stock one ?
What is the tire name i like it
How long did it take to remove the turbos?
Hard to tell since we were recording
Thoughts on weistec w.4 ? Are they just taxed for the names sake
Yes
Pure1000 and you’re good to go
I heard pure is using Chinese junk now....
Did u remap stage 3 for turbo upgrade?
We did although it isn't required
Aftermarket intake in engine bay intake? So change from stock cold air intake to aftermarket hot air intake. Hot air has a lower density, so less air equals less power. The owner is an amateur!
Since when hot air has lower density?
cold air has lower density that is why we use intercoolers of any kind to lower air temp
🤩🤩🤩🤩🤩😎😎😎👍👍👍👏👏👏
🙏🏼🙏🏼
How was the performance gain?
@@Need2SpeedSTL very good! They turbos didn't have to try as hard and now it's ready for more boost!
How long did it take to remove the turbos?
Not very long. Hard to tell the actual time since we were recording