ASME II Parts and Allowable Stress Values in Section II Part D - API 510, API SIFE Exams

This video by Bob Rasooli explains about ASME Section II Part A (Ferrous material), B (non-ferrous material), C (welding rods and electrodes) and D (material properties). Besides, states how Part D is used to get allowable stress value to calculate pressure vessel wall thickness at different design temperature. A typical question on ASME, API 510 Piping Inspector, API SIFE (Source Inspector Fixed Equipment) Exams.
Link to API 510 Pressure Vessel Inspector Online Training Course: www.inspection-for-industry.c...
Link to API SIFE - Source Inspector Fixed Equipment Online Training Course: www.inspection-for-industry.c...
Link to ASME Online Training Course: www.inspection-for-industry.c...

[@hareshahir8248]

Very nice... Sir... Thank you..

[@AnkushSingh-kj1zl]

Thank you sir

[@Jshomette]

Great video. It would help if you went into the application of Table 1A vs Table 2A. I see many times where users are incorrectly using Table 2A allowable stress values for Section VIII, Div. 1 equipment evaluations. The allowable stress values in Table 2A are generally higher than Table 1A due to the more rigorous design of Section III Nuclear equipment but these stress values cannot be applied to Section VIII, Div. 1 equipment...

[@tajanwar1496]

Make a video of how to check chemical composition tolerance acceptable criteria on minimum basis.

[@tayyabali9212]

nice

[@i4i-academy]

Thanks