Have an 09 mariner.. loud clunking/clicking noise coming from the center of the steering while driving and making a turn. What would it be? Replaced stem joint, rack n pinion, cv shafts, torque sensor And still can't trouble shoot it.
Yes. After replace the tie rods. You. Need to to do alignment. So you angle sensor. Or steering wheel sensor. Is set at 0 degrees with the steering wheel straight.
@@pacobus24 yes. Just make sure. When they do the alignment. They check. That the angle sensor or steering wheel sensor. Or torque sensor. Is. At 0 degrees with the steering wheel straight. Then can do the adjustment on the tie rods.
i found my battery was in need of charge or replacement on a escape when steering went from power to standard fixed the problem there was no message on dash also my buick had the abs and other lights on dash turned out to be rear wheel bearing
@@azul93gt38 that’s why we need to. Diagnostic. The problem first. In this case. Because the symptoms. Take me to do the. Sensor. The data that was showing on my scanner was. Out of range. When the steering wheel is in the center position. The sensor should. Show. 0 degrees.
Snap Ring 😎 Great video.
Thank you. If you have any questions in the future. Just drop it here. I will do my best to help. 😀
@NormanMangusin_FLM any question leave here. 😃😃😃😄
Have an 09 mariner.. loud clunking/clicking noise coming from the center of the steering while driving and making a turn. What would it be? Replaced stem joint, rack n pinion, cv shafts, torque sensor And still can't trouble shoot it.
Can you record a video and. Send it to me. Find me on facexxk. Colas solorzano
I just replaced the control arms tie rods and sway bars and now I'm receiving the message. Does something need to be reset?!
Yes. After replace the tie rods. You. Need to to do alignment. So you angle sensor. Or steering wheel sensor. Is set at 0 degrees with the steering wheel straight.
@@1Wayfix and then the power steering assist fault will go off?! I have never seen this notification until after new tie rods
@@pacobus24 yes. Just make sure. When they do the alignment. They check. That the angle sensor or steering wheel sensor. Or torque sensor. Is. At 0 degrees with the steering wheel straight. Then can do the adjustment on the tie rods.
i found my battery was in need of charge or replacement on a escape when steering went from power to standard fixed the problem there was no message on dash also my buick had the abs and other lights on dash turned out to be rear wheel bearing
I glad you got it fix it 👍💪 any question leave here I will do my best to help
Torque sensor didn’t work with new one
@@IceColdCreeper can you explain please?
What size snap ring pliers did you use.
I got the set from harbor freight. And dont show the size. For it.
I replace the sensor with new and still have the same problem
Turn the car off and steering wheel work again
Did you reset the codes
Have you tried another battery. ?
Some people have had to replace the whole column assembly, CL8Z 3C529 D, which is the electric power steering motor.
@@azul93gt38 that’s why we need to. Diagnostic. The problem first. In this case. Because the symptoms. Take me to do the. Sensor. The data that was showing on my scanner was. Out of range. When the steering wheel is in the center position. The sensor should. Show. 0 degrees.
Can you share the link ?
What link do you need?
Power Steering Seals - Sensor de... www.amazon.com/dp/B07VQRMN22?ref=ppx_pop_mob_ap_share
Power Steering Seals - Sensor de... www.amazon.com/dp/B07VQRMN22?ref=ppx_pop_mob_ap_share