74 chieftain 165 hp

แชร์
ฝัง
  • เผยแพร่เมื่อ 7 พ.ย. 2024

ความคิดเห็น • 14

  • @captlarry-3525
    @captlarry-3525 5 ปีที่แล้ว

    Very pretty boat, and maybe the ideal motor set up. Although I am still looking for a video of a chieftan underway with the 4 cyl. hope there are videos of the restoration, and boat underway..

    • @cj8mule
      @cj8mule  5 ปีที่แล้ว

      I don't remember many videos of the chieftain in the water. There is one short video on my TH-cam channel. There is also a nice restore thread on the starcraft forum on iboats.com

  • @captlarry-3525
    @captlarry-3525 5 ปีที่แล้ว

    Just like downtown !

  • @soeuthsvay4983
    @soeuthsvay4983 9 ปีที่แล้ว

    how much it cost to wiring in boat??? my outdrive stuck could not pull out. the boat sat for 20 years

    • @cj8mule
      @cj8mule  9 ปีที่แล้ว

      +Soeuth Svay I'm not sure. I just kept the original wire harness and added new circuits for my accesseries. There's a lot to the wiring of that outdrive. You should go to iboats.com and look into the mercruiser forum. Those guys can get you the right diagram.

  • @tnaburbs
    @tnaburbs 9 ปีที่แล้ว

    nice job sounds great what ratio is the outdrive

    • @cj8mule
      @cj8mule  9 ปีที่แล้ว

      Travis B Thanks, we put close to 200 hours on this engine last season and is still running strong. The gear ratio is 1.65.

    • @tnaburbs
      @tnaburbs 9 ปีที่แล้ว

      installing a 165 into my 88 islander 221 hardtop did your chieftain have the 3.0 before?

    • @cj8mule
      @cj8mule  9 ปีที่แล้ว

      Travis B No, the 165 was original in this one... but had to repower it due to PO neglect. Here's a condensed rebuild thread on iboats: forums.iboats.com/forum/boat-repair-and-restoration/completed-boat-projects/9397360-1974-21-chieftain-165-mercruiser-restoration

  • @soeuthsvay4983
    @soeuthsvay4983 9 ปีที่แล้ว

    can u tell me how to remove aluminum penal the top of transom?

    • @cj8mule
      @cj8mule  9 ปีที่แล้ว

      +Soeuth Svay It's not that bad, but it does take some work. To take the top panel off, you have to remove the rub rail rubber on the sides and back. Then, take out the screws holding on the aluminium rub rail. Then, remove screws and rivets holding the aluminium panel. You can go here for lots of examples and help: forums.iboats.com/forum/owners-groups-by-manufacturer/s/starcraft-boats

  • @jrisinlove
    @jrisinlove 10 ปีที่แล้ว

    How fast is your boat?

    • @cj8mule
      @cj8mule  10 ปีที่แล้ว

      around 36 mph on the gps

    • @jrisinlove
      @jrisinlove 10 ปีที่แล้ว

      Wow that is pretty good for a mercruiser 165hp 250cid. Keep up the good work