Yes with about 2 turns on the screw the middle cylinder gets to hot, so max recommended is 1,5 turs. So it seems like its well proved on this engine according to internet. The drone video is from the island I did the excavation for an extension on a building and took down a stone wall.
Nice video man, interesting to see before and after prestandas. If you're gonna push the engine a lot during longer interwalls one way to help it hold would be to install a intercooler. It also would gain some hp and help you hold down the temperature on your engine, a win win situation so to speak. Since you got that pressure pipe between the turbo and the intakemanifold the operation shouldn't be way to expensive, the piping back and forth to the front of the watercooler will be worst part of course. I had plans doing it on a Valmet 405 I had but failed in motivation and time. I wish you better luck and strength.
Thanks, glad you liked it. I sold the valmet before I got a chance to do something more, but the difference was amazing, like a new tractor after tuning. The only problem with it was no clutch less changing between forward reverse...
Interesting results. I am glad you did a before and after. With gasoline engines, leaning the mixture will provide more power. (with risk of run hotter and pre-ignition). I do not know with diesel, if that is the same. Did your adjustment lean the air/fuel mixture, or make it richer? Thanks for your videos.
Jag hade gasen lös på pumpen i min Case 1294 efter att jag spänt fast gasen varvar den bättre och gick hårdare jag har tre kompisar som har en Valmet 605, Valmet 705 och em Valmet 805 hälsningar från Svensk Finland 😁🇫🇮
Suksess. :-) Kan sikkert skru en halv runde til. Som du sier så pass på varmen. Min 1056XL har etter montert turbo og justert opp fra 105 Hk originalt til 136 Hk på tappen, noe som tilsvarer ca 145 i motor. Jeg har montert en ekstra kjølevifte til de virkelig tunge dagene. med en enkel av på bryter. Fint å se litt dagslys hos deg også.
Message in English will follow E d i Akkarfjorn du har vært m drona å flydd? Har ikke vært oppe på fjellet der på vinteren, men d va jo nydeli utsikt. Godt å få skrudd opp pumpa litt ja. Mye mer effektiv gange når du får mer diesel. ---- The dronefootage is from Sørøya? I haven't been up in those mountains during the wintertime, but an astounding view. Adjusting the pump for more diesel is good for power. More diesel = more power.
Yes it's Akkarfjord same place I did the excavation out on a island. It's really nice out there driving snowmobiles in the winter. Drone video is from last year.
I like your hat it look good on you I bet it keep your ears warm. Do you have headlights because I don't see any lights on the road when you you driving
Thanks, yes it's nice when it's cold out ❄️ Yes I do, I but they are behind the bucket, so I installed an small ledbar on top of the hood, but it's probably hard to see the light from it on the screen. It's most for other traffic to see me
I'm using an dji phantom 4adv here, and I also got an small spark that is better on auto follow, except in this video where it crashed in a pole 🤣 th-cam.com/video/Sh_Sqbbx0oI/w-d-xo.html
There will be more daylight now, but the problem is I'm at my day job when it's daylight 😔 but now it's not dark before around 6 in the evening so it will be better
Awesome, you did a great job!!! Thank you for your videos, we are lucky to have you to entertain us during this crisis.
Glad you enjoy it!
Awesome but will Greta approve of you using more fuel 😂😂😂😂😎 good to see the internet working for you on how to maximize your tractor power .
he will use less diesel when he is working with it. can do same job with less rpm. he gains NM.
He he let's hope she doesn't notice😅 Yes internet is awesome :)
Be careful when turning the fuel up. It may increase exhaust temperatures. Great video. Love the drone footage at the end
Yes with about 2 turns on the screw the middle cylinder gets to hot, so max recommended is 1,5 turs. So it seems like its well proved on this engine according to internet. The drone video is from the island I did the excavation for an extension on a building and took down a stone wall.
Nice video man, interesting to see before and after prestandas. If you're gonna push the engine a lot during longer interwalls one way to help it hold would be to install a intercooler. It also would gain some hp and help you hold down the temperature on your engine, a win win situation so to speak. Since you got that pressure pipe between the turbo and the intakemanifold the operation shouldn't be way to expensive, the piping back and forth to the front of the watercooler will be worst part of course. I had plans doing it on a Valmet 405 I had but failed in motivation and time. I wish you better luck and strength.
Thanks, glad you liked it. I sold the valmet before I got a chance to do something more, but the difference was amazing, like a new tractor after tuning.
The only problem with it was no clutch less changing between forward reverse...
Interesting results. I am glad you did a before and after.
With gasoline engines, leaning the mixture will provide more power. (with risk of run hotter and pre-ignition).
I do not know with diesel, if that is the same. Did your adjustment lean the air/fuel mixture, or make it richer?
Thanks for your videos.
More fuel = more power on a diesel, and a diesel without wastgate it also means higher boost pressure
Yes I knew the hill was an challenge before so was nice to see the change 😀
Like your vidios no more snow
Jag hade gasen lös på pumpen i min Case 1294 efter att jag spänt fast gasen varvar den bättre och gick hårdare jag har tre kompisar som har en Valmet 605, Valmet 705 och em Valmet 805 hälsningar från Svensk Finland 😁🇫🇮
Nice drone shots
Thanks 👍
Bra video👍🏻😎
Takk
Too dark, we see nothing!
Sorry I checked with my phone now and it was much darker then in editing, I had to much faith in the little daylight I had 😔
Suksess. :-) Kan sikkert skru en halv runde til. Som du sier så pass på varmen. Min 1056XL har etter montert turbo og justert opp fra 105 Hk originalt til 136 Hk på tappen, noe som tilsvarer ca 145 i motor. Jeg har montert en ekstra kjølevifte til de virkelig tunge dagene. med en enkel av på bryter. Fint å se litt dagslys hos deg også.
Message in English will follow
E d i Akkarfjorn du har vært m drona å flydd? Har ikke vært oppe på fjellet der på vinteren, men d va jo nydeli utsikt.
Godt å få skrudd opp pumpa litt ja. Mye mer effektiv gange når du får mer diesel.
----
The dronefootage is from Sørøya? I haven't been up in those mountains during the wintertime, but an astounding view.
Adjusting the pump for more diesel is good for power. More diesel = more power.
Yes it's Akkarfjord same place I did the excavation out on a island. It's really nice out there driving snowmobiles in the winter. Drone video is from last year.
Would have been nice video with a light !
Yes to much faith in our little daylight 😔 sorry
Great to see you this week , will your piles of snow melt and be gone by June ?
Me and the kids was out yesterday measuring them, the highest is 4,3 meters high so I'm starting to wonder if I will see the lawn this year 😂
I like your hat it look good on you I bet it keep your ears warm. Do you have headlights because I don't see any lights on the road when you you driving
Thanks, yes it's nice when it's cold out ❄️ Yes I do, I but they are behind the bucket, so I installed an small ledbar on top of the hood, but it's probably hard to see the light from it on the screen. It's most for other traffic to see me
What drone are you using?
I'm using an dji phantom 4adv here, and I also got an small spark that is better on auto follow, except in this video where it crashed in a pole 🤣 th-cam.com/video/Sh_Sqbbx0oI/w-d-xo.html
TRY bending the end of the wrench ???
If I was suppose to do this often I would bend it but not worth bending it for one time 😊
You need to add intercooler.
Yes and some nos for when the snowblower get really full 😁 but an intercooler would probably give me a few extra hp 👍
Check your camera lighting before doing the actual work
Yes sadly I didn't have enough lights for this video, but was hard to do over with all the snow we had last year.
Make movies in daytime if you can
There will be more daylight now, but the problem is I'm at my day job when it's daylight 😔 but now it's not dark before around 6 in the evening so it will be better
@@MiniMachines1 I see, looking forward to see more
Bra video👍🏻😎
Forresten hvor mange timer har den gått?
@@andreasrang5031 8-9000😁 knapt nok innkjørt 😀
Mini Machines sant det! 😄 disse holder jo over 20 000 timer med bra service!😎 gått 86xx min👍🏻