How to Replace Crankshaft Position Sensor 2013-2017 Honda Accord

Buy Now!
New Crankshaft Position Sensor from 1AAuto.com 1aau.to/ia/HTEC...
This video shows you how to install a new crankshaft position sensor from TRQ on your 2013-2017 Honda Accord. The crankshaft position sensor is an important component of any electronically controlled ignition system. The sensor provides the computer with data about the position of the crank shaft to properly adjust ignition timing. If the sensor in your vehicle is broken or malfunctioning, you may suffer poor performance, or get a check engine light.
Once the sensor is installed, you will need to follow the relearn procedure. This can either be done with a manufacturer scan tool, or manually with the following procedure:
1.
Start the engine. Hold the engine speed at 3,000 rpm without load (A/T and CVT in P or N, M/T in neutral) until the radiator fan comes on.
2.
Test-drive the vehicle on a level road: Decelerate (with the throttle fully closed) from an engine speed of 2,500 rpm down to 1,000 rpm with the transmission in 2nd.
3.
Repeat step 2 several times.
4.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, and wait an hour. The CKP pattern learn procedure is complete.
This process should be similar on the following vehicles:
2013 Honda Accord
2014 Honda Accord
2015 Honda Accord
2016 Honda Accord
2017 Honda Accord
Tools you will need:
• 10mm Socket 1aau.to/obj9/1A...
• 1/4 Inch Ratchet 1aau.to/obj9/1A...
• 3/8 Inch Drive Ratchet 1aau.to/obFm/1A...
• Torque Wrench 1aau.to/oaNb/1A...
• Gloves 1aau.to/oaoL/1A...
• Safety Glasses
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@musicalokaoficial]

Awesome you saved some money here good fellas. Thank you very much

[@abatenate]

Will this process be the same for the crv?

[@marcovivanco5534]

Doesn’t matter if it’s a 4 cylinder or v6 they only have one sensor for the crankshaft and You don’t have to disconnect the plastic from the metal plate it makes it easir.

[@Ehricj]

How far off the ground should the car be

[@asid731]

Is this a four or six cylinder?

[@kanwardeepsb]

For v6 or 4 cylinder engine

[@betoavilez7180]

Now I can’t get to reset the sensor ?

[@crisco431]

Awsome thank u so much