I upgraded my fuel pump with a Walbro 255 in preparation for an LS swap before watching this video. I had watched some other videos. After I did fuel pump job and it ops checked good, a short time later I had a no start condition. After some trouble shooting without success, I just happened to be watching this video ^ and at about the 3:10 minute mark, I realized what I had done. After removing the bed, I had left the ground to the fuel pump loosely attached which effectively ungrounded the fuel pump circuit. This video saved me from having to hire a real mechanic to get me going again. Thank you.
We've moved all of the car related videos to a NEW CHANNEL! youtube.com/@GearHeadsFHS Make Sure you're following over there for all future automotive videos
Damn man you must be in the northeast your frame and all under the bed is rusted as F lol I need to find out if my ground is hood because my gas gauge is not working good video
Great video.Seems easy enough. Thank you. Just one question, do you need to do anything else with the rear tail lights? I mean you showed the two ground straps, but do you need to remove the tail lights and wiring?
I upgraded my fuel pump with a Walbro 255 in preparation for an LS swap before watching this video. I had watched some other videos. After I did fuel pump job and it ops checked good, a short time later I had a no start condition. After some trouble shooting without success, I just happened to be watching this video ^ and at about the 3:10 minute mark, I realized what I had done. After removing the bed, I had left the ground to the fuel pump loosely attached which effectively ungrounded the fuel pump circuit. This video saved me from having to hire a real mechanic to get me going again. Thank you.
We've moved all of the car related videos to a NEW CHANNEL! youtube.com/@GearHeadsFHS
Make Sure you're following over there for all future automotive videos
The most important step is the wiring and he didn't even bother to show it..👌
oh come on, morning better to do than talk shit ?
My 98 Sonoma the eight bolts holding the bed on came off smooth as silk with a breaker bar that was a relief!
Lucky af
I think I'm going to cut a hole in my bed and cap it.
I agree
It would be more helpful if you said the size of the nuts and bolts you were removing
Damn man you must be in the northeast your frame and all under the bed is rusted as F lol I need to find out if my ground is hood because my gas gauge is not working good video
Life in ohio. Rust is like corn. Fucking everywhere.
Great video.Seems easy enough. Thank you. Just one question, do you need to do anything else with the rear tail lights? I mean you showed the two ground straps, but do you need to remove the tail lights and wiring?
That is correct. There’s a couple of harnesses you disconnect. The ground straps are just the only ones wired with bolts.
Thank you!
@@FinallyHeSleeps
What size are the bolts on the gas door
The bolts around the filler pipe require a 7 (seven) millimeter socket.
So it must not have started back up?
Well there's one thing i don't gotta worry about... My fuel housing bolts are non existing 😂
I wouldn't drive that MF any further than I'd drive the POS I got.
Where you at? your bed is way rusty
Ohio. Everything is rusty and this is a rust box.