Check out my electrical video. It has a little more footage from the wiring side. I used a sheet of HDPE plastic to make the tray. Do you mean the panel on the dash?
@@GunsandTactics no I meant the bus bars on the HDPE. You used several of the so wasn’t sure how all that works. Actually, didnyknow you use bus bars on this unit. I will look at your other video. Thanks again for your response
Bus bars are just for the accessories ground. The positive lead came from the switch pro and then the negative went to the bar. I didn’t want to ground locally near the accessory or frame etc and ran two leads to each item if that makes sense
Question about the Switch Pro. Can you program it so that one of the switches is a 3 position? Basically an On/Off/On. Here’s the situation. I have a Yamaha YXZ and the radiator is mounted behind the cab. Normally the fans suck the air from the cab and is blown out of the rear of the vehicle, however it’s possible to reverse the polarity since it’s DC and cause the fans to change direction and blow the heat into the cab. Great for the cold Montana winters.
You could program one switch to off-on-on easy enough, however you’d have to use two outputs I think as I haven’t seen a way to reverse polarity in the Switch-Pros
6:35 THIS!
Can you show us what you used for the panel and connectors and why you did it and what its for. New to wiring. Thanks
Check out my electrical video. It has a little more footage from the wiring side. I used a sheet of HDPE plastic to make the tray. Do you mean the panel on the dash?
@@GunsandTactics no I meant the bus bars on the HDPE. You used several of the so wasn’t sure how all that works. Actually, didnyknow you use bus bars on this unit. I will look at your other video. Thanks again for your response
Bus bars are just for the accessories ground. The positive lead came from the switch pro and then the negative went to the bar. I didn’t want to ground locally near the accessory or frame etc and ran two leads to each item if that makes sense
Question about the Switch Pro. Can you program it so that one of the switches is a 3 position? Basically an On/Off/On. Here’s the situation. I have a Yamaha YXZ and the radiator is mounted behind the cab. Normally the fans suck the air from the cab and is blown out of the rear of the vehicle, however it’s possible to reverse the polarity since it’s DC and cause the fans to change direction and blow the heat into the cab. Great for the cold Montana winters.
You could program one switch to off-on-on easy enough, however you’d have to use two outputs I think as I haven’t seen a way to reverse polarity in the Switch-Pros
Timms seems to like things that way
Piss poor planning = piss poor performance
Yikes thats expensive
We pay for convenience these days