Great video and from my own expereince --- Bumber off -- Remove the plastic air vents (two each side) watch your hands as the grills are a tight fit. Fluffy pads out and leave them out as they make no sound difference. There is already a hole with a rubber bung in each well area base --remove the bung and drill a sensible size hole in it and then replace to allow any drainage . Worth also brushing a good old coating of something like waxoly in the well areas before replacing the 4 air vents .. bumper back on and job done...
hi ya Neil thankyou so much . couple of questions i reckon i could do this DIY .but you would you say replace the wadding /pad .replace with new or leave out if so can you buy a similar product thanks
Thanks for watching, yea give it a go, I’m no mechanic but this is DIY doable 👍🏼 I personally have left the wadding out, purely as I couldn’t find anything similar, it’s been fine since doing so…. Good luck 👍🏼
Great video and from my own expereince --- Bumber off -- Remove the plastic air vents (two each side) watch your hands as the grills are a tight fit. Fluffy pads out and leave them out as they make no sound difference. There is already a hole with a rubber bung in each well area base --remove the bung and drill a sensible size hole in it and then replace to allow any drainage . Worth also brushing a good old coating of something like waxoly in the well areas before replacing the 4 air vents .. bumper back on and job done...
Thanks for watching and your comment 👍🏼
hi ya Neil thankyou so much . couple of questions i reckon i could do this DIY .but you would you say replace the wadding /pad .replace with new or leave out if so can you buy a similar product thanks
I was wondering the same thing should you replace the foam padding or leave it out
Thanks for watching, yea give it a go, I’m no mechanic but this is DIY doable 👍🏼
I personally have left the wadding out, purely as I couldn’t find anything similar, it’s been fine since doing so….
Good luck 👍🏼
Hi Neil,where are you situated,I would like you to sort out that issue for me
Can I just cover those vents just weld them solid
Top man
No problem glad it helped you out
How much would it cost
Depending what the hourly labour rate is at your garage, but it’s around 2-3 hours work
thx
Hope it helps you out 👍🏼
just pull the water plugs out