When you turn it backwards it activates the starter and the crank where if you turn it the other way it just turns your crank. Either way is fine and turning the opposite way is a good way to check for starter issues and cog alignment
if the engine is seized, it could be a number of problems. something could be internally wrong with the kickstart gear, could have bad crankshaft berrings, piston could be screwd, like you said timing chain could be stuck in the bottom end, valves could be adjusted wayy too much, valves could be bent(would still kick but would be very hard to) camshaft could be screwd with too.
Question: what year is this bike i only seem to see 2 holes to line up on my cam shaft unless i missed one want to get my timing right before i put all the parts back together. I have a 2001 raptor
it will kick, but not start. if the timing chain is broken, you are not allowing the valves to move which not allowing fuel, or exhaust to enter/exit cumbustion chamber. therefore not allowing it to start.
lmao information is right just not fully explained you need to be on the compression stroke to set the timing, id say if you dont know that you should done a little more research before you tried to do it
![Sneaky motorcycle cam chain replacement technic how to Davidsfarmison[bliptv]now](/img/n.gif)
When you turn it backwards it activates the starter and the crank where if you turn it the other way it just turns your crank. Either way is fine and turning the opposite way is a good way to check for starter issues and cog alignment
thank you for the information! helps me a lot
sijto molina -!%&
Tdc is after the intake valves close before the exhaust opens
if the engine is seized, it could be a number of problems. something could be internally wrong with the kickstart gear, could have bad crankshaft berrings, piston could be screwd, like you said timing chain could be stuck in the bottom end, valves could be adjusted wayy too much, valves could be bent(would still kick but would be very hard to) camshaft could be screwd with too.
what is the timing chain marks on 350cc feishen atv
How about what Mark so I don't have to pull the valve cover. Duh.
Question: what year is this bike i only seem to see 2 holes to line up on my cam shaft unless i missed one want to get my timing right before i put all the parts back together. I have a 2001 raptor
Did you ever figure it out cause I’m having the same issue atm
I have yamaha raptor 660 what is the h for for timimg
I have a Kazuma 150 atv it gets fire an gas what else can i check cause it wont start
compression, fuel sample, clean carb, use starting fluid
@@codylippincott1764 what if it starts but stalls when gased?
I have a dirt bike eith a loncin 250 engine and it sounds like the timing chain is loose - any one know if there is an adjuster to thighten it up ?
it would be on the side of the timing chain usually on the back side of the head around Bolt with two little boats on the side
can anyone tell me what markings to use to set timing on 1989 Honda fourtrax two wheeldrive
it will kick, but not start. if the timing chain is broken, you are not allowing the valves to move which not allowing fuel, or exhaust to enter/exit cumbustion chamber. therefore not allowing it to start.
also could have a stuck valve that would also keep it from starting and it wouldnt have compression
whers ya guide stoper ?
Aye
Grizzly 700
This guy is Giving WRONG information do not watch this....
What's wrong the line or h part?
James R. Hellmsly what mark do you use? putting mine back together and can't get it
Yea and my lines don't line up perfectly
True timing is off, thanks Dick head. Wrong information!!!
lmao information is right just not fully explained you need to be on the compression stroke to set the timing, id say if you dont know that you should done a little more research before you tried to do it