1.8 degree stepper motor teardown & construction display

[@Ludanc0]

This video was very useful, you helped me save my resin printer, thanks.

[@rizkydwi4622]

Pretty simple, but very useful! Thanks.

[@en2oh]

any interest in tearing the rotor apart? I'm wondering about changing the rotor shaft

[@Sandman755]

Thanks for that. Is there a fault that can occur with the motor that would cause it to turn by more than its 1.8 degrees? I have a stepper motor that, I think, is moving further than it should be per step.

[@ATOcom]

This may be related to the driver you are using. The driver can adjust the number of pulses required for each revolution of the motor.

[@Lucky84-11]

Sir what is the wire size of the coil?

[@imaminsyafilah6918]

Makasih bgt boss