Awesome Homemade Cross Slider And Screw Nut Threading Going to Work

[@medshop2931]

Vary good job thank you

[@mr.ranyhomemade2466]

Thank you for reaching I do hope you like it

[@GBWM_CNC]

Good job!

[@mr.ranyhomemade2466]

Thank you my friend

[@ÁREAJ27]

Olá meu amigo trabalho perfeito, muito boa a ideia!!!Lhe desejo sempre muita saúde e cada vez mais sucesso!!!
Abraço

[@mr.ranyhomemade2466]

Olá meu querido amigo, como você está? como você tem estado? obrigado por assistir espero que tenha gostado qual é o seu projeto? eu espero tudo de bom

[@MrPov5]

Nice job brother ❤❤❤

[@cicerogambiarra6324]

Boa tarde amigo tá ficando tope que Deus abesoi

[@yatinpanchal3060]

👍🙏

[@mr.ranyhomemade2466]

Thank you

[@JvViana-c7z]

Muito bom seu trabalho; gosto muito de ver seus videos. muito o brigado amigo.

[@danvandertorre6349]

good job I think you are going to have to put an adjustable slider inside your cross slide to take up side-to-side movement in it as it wheres out.

[@mr.ranyhomemade2466]

Many thanks I appreciated your introduction because I had stuck ideas too sometimes.
Otherwise, I make it not in the role of a homemade lathe sometimes made this or a different way because behind the scene very hard to make these cause I don't have any tools and equipment enough. Right now I'm stuck gear rack for the tracking carriage where do I get it? I could find it online but I don't have an address because I'm living in the village. So my work is always slow.
Thank you for watchingng...

[@hoernst2762]

Respekt vor ihrer Arbeit! Ich sehe den Kanal gerne. Leider kann TH-cam nicht übersetzen,

[@devilvortex1]

perhaps it is better not to go so deep with the milling cutter with your homemade drill.

[@mr.ranyhomemade2466]

Thanks