ANSYS Nonlinear Buckling Analysis of Stiffened Plate (Johnson-Cook-Power Law Plasticity)

แชร์
ฝัง
  • เผยแพร่เมื่อ 23 ธ.ค. 2024

ความคิดเห็น • 9

  • @berkealbayrak8048
    @berkealbayrak8048 4 ปีที่แล้ว +1

    very helpful, im in my 6th year and now i'll finally graduate thanks to you mr. buyukkoyuncu

    • @mericbuyukkoyuncu385
      @mericbuyukkoyuncu385  4 ปีที่แล้ว

      I am very happy to see that my videos help somebody. Thank you for your good comment.

  • @Alirezaghalamkari
    @Alirezaghalamkari 21 วันที่ผ่านมา

    Can I ask why did you define boundary condition for the bottom nodes in two different discpacement ? once you defined Z=0 and then add an other discpalacement condition for Y=3mm . I assumed we could define both in one displacement condition, is there any specific reason to divide it in two ? Thank you

  • @ozgekececi5197
    @ozgekececi5197 4 ปีที่แล้ว +1

    great job 👏

  • @somethingdifferent1910
    @somethingdifferent1910 ปีที่แล้ว

    Hello sir, Is there an any way that you can share the Johson-Cook pdf?

  • @hitman5601
    @hitman5601 2 ปีที่แล้ว

    How to define Johnson cook failure constant in ansys

  • @hassankandil3691
    @hassankandil3691 2 ปีที่แล้ว

    Very helpful, Thank you very much

  • @hakansezen2019
    @hakansezen2019 4 ปีที่แล้ว +1

    ERROR = "An unknown error occurred during solution. Check the Solver Output on the Solution Information object for possible causes."
    WARNING= "The unconverged solution (identified as Substep 999999) is output for analysis debug purposes. Results at this time should not be used for any other purpose."
    Aynı işlemleri yaptım fakat sonuç yakınsamadı videodakilerden farklı hiçbir şey yapmadım internette bazı sayfalarda bu uyarı için time sizing arttırın deniyor. min substepi 10 max substepi 1000 e getirdim tekrar aynı hatayı aldım.

    • @mericbuyukkoyuncu385
      @mericbuyukkoyuncu385  4 ปีที่แล้ว

      Evet bazen yakınsamıyor, initial substep i artırabilirsin, malzeme datasını kontrol edebilirsin, energy değerini değiştirebilirsin, mesh i iyileştirebilirsin vs vs. Çok fazla yöntem var.