I just bought one of these things. The directions seem to be a potpourri of languages and no mention of calibration. Do you know if there are any written procedures out there?
Anyone use this on their 23cm setup? I seem to have SWR results that are all over the board. The unit goes berserk above 1000mhz even into a dummy load. Anyone have any success?
I just compared which to use my KC901V at the 1295Mhz on the Diamond tri-band mobile antenna SG9500, as the MINI1300 results are almost the same with KV901V. My Mini1300 firmware version is v1.04.
@@TingILi Thanks for that comparison. Ultimately I did end up getting the Mini to work properly- I had a setting set wrong (I can't remember exactly what it was right now), but once I figured out my mistake, the unit worked as it should. Thanks!
can you provide some assistance on how to calibrate the mini 1300
Hi, Can you make VDO how to use the MINI .1-1300Mhz or the .1-600Mhz Pls.
I just bought one of these things. The directions seem to be a potpourri of languages and no mention of calibration. Do you know if there are any written procedures out there?
can u show me the close up the antena calibrated please witch prongs do i need to solder them on??
Anyone use this on their 23cm setup? I seem to have SWR results that are all over the board. The unit goes berserk above 1000mhz even into a dummy load. Anyone have any success?
I just compared which to use my KC901V at the 1295Mhz on the Diamond tri-band mobile antenna SG9500, as the MINI1300 results are almost the same with KV901V. My Mini1300 firmware version is v1.04.
@@TingILi Thanks for that comparison. Ultimately I did end up getting the Mini to work properly- I had a setting set wrong (I can't remember exactly what it was right now), but once I figured out my mistake, the unit worked as it should. Thanks!
Amazon says the 1300 is not in stocks so does anybody information on where I can purchase ty 7 3
What a complete waste of time. Why would we want to watch someone soldering SMDs from several feet away. What is being soldered and where to?
Please normalize your audio when making your videos, Thanks!
w t f