Begininers guide to making a mold for a Fiberglass rear bumper.

แชร์
ฝัง
  • เผยแพร่เมื่อ 31 ม.ค. 2025

ความคิดเห็น •

  • @dominikkozela9763
    @dominikkozela9763 2 ปีที่แล้ว +1

    Nice to see it done properly

  • @amakadius75
    @amakadius75 2 ปีที่แล้ว +4

    What product is the gel coat for the molding

  • @mdscownz
    @mdscownz ปีที่แล้ว +4

    What did you use to secure it to the car? Did you transfer the clips to the backside of the finished product or get creative?

    • @TOOLRacingteam
      @TOOLRacingteam  ปีที่แล้ว +3

      The screw heads you see on the back of the bumper connect to the original internal plastic (I think) bumper. This was heavily lightened though.

  • @ErnieHernandezdesigner
    @ErnieHernandezdesigner 2 ปีที่แล้ว

    👍

  • @jona_ej2330
    @jona_ej2330 2 ปีที่แล้ว +2

    Why in 3 pieces?

    • @TOOLRacingteam
      @TOOLRacingteam  2 ปีที่แล้ว +5

      It makes it easier to release the part.

  • @nylezfuller4746
    @nylezfuller4746 7 หลายเดือนก่อน

    A demonstration would help…