It's easier to do from the front. Too much work pulling the unit away from the wall and disconnecting the water hoses and dryer vent. All you have to do is remove the control panel and front panel. Remove the Dryer Belt. Remover the 3 screws holding the Drum. Lift out the Drum and put aside. Now you have access to the Motor and Blower. Remover the screws on the front of the Blower, remove the E-Clip. Remover the Plastic Shroud from the front, remove the Blower Wheel, than remove the additional screws to remove the back of the plastic blower shroud. Now you have full access from the front to change the motor. The Drum is difficult to line up with the 3 screws in the back, so put some books under the Drum and tip it up and down to line up the first screw hole. Once the first screw is partly installed, the other two are usually easy to line up, or put a small screw driver in one or 2 of the holes to isolate that 3rd screw hole, and than put the first screw in that way. Remember to remove the books.
It's easier to do from the front. Too much work pulling the unit away from the wall and disconnecting the water hoses and dryer vent. All you have to do is remove the control panel and front panel. Remove the Dryer Belt. Remover the 3 screws holding the Drum. Lift out the Drum and put aside. Now you have access to the Motor and Blower. Remover the screws on the front of the Blower, remove the E-Clip. Remover the Plastic Shroud from the front, remove the Blower Wheel, than remove the additional screws to remove the back of the plastic blower shroud. Now you have full access from the front to change the motor. The Drum is difficult to line up with the 3 screws in the back, so put some books under the Drum and tip it up and down to line up the first screw hole. Once the first screw is partly installed, the other two are usually easy to line up, or put a small screw driver in one or 2 of the holes to isolate that 3rd screw hole, and than put the first screw in that way. Remember to remove the books.
Thank you for this video. I was successful in replacing my dryer motor.
Nicely done, thanks for taking your time,
What is the part number for the motor and blower wheel assembly?
Whats the drum stop part number?