Allen Bradley Powerflex 4 local mode set up and Factory reset Single phase (English)

Tutorial for Allen Bardley Powerflex 4 local mode set up and Factory reset, basic programming and speed control. See manuals and related videos below. Drive is single phase to 3 phase, so it can be run from 220-240v single phase supply.
Direct contact on Linked in: / ingus-sudints-1b2a2517a
Allen Bradley Powerflex 4 Inverter drive: igselectronics.co.uk/products...
Schneider Electric Buttons: Harmony XB4 complete unit XB4BA31
Website: igselectronics.co.uk/
Allen Bradley Powerflex 4 remote control wiring: • Allen Bradley Powerfle...
Run a 3 phase motor on single phase power, basics: • Run a 3 phase motor on...
Single phase to 3 phase inverter drive home setup: • Single phase to 3 phas...
Manual Powerflex 4 Quick start guide: literature.rockwellautomation...
Manual Powerflex 4 Full: literature.rockwellautomation...

[@IGSElectronics]

Hello Fellow colleagues. If you enjoy the video please click that like button and if you did not, dislike it and let us know in comments, what was, that made you not happy with the content, so I can learn from it and make better videos for you in the future. Have a great day everyone.

[@walternowacki1513]

Awesome Video very good on explaining.

[@djimizar2555]

Thank you

[@martinmartinezreyes975]

Muy buenos. Lo videos maestro

[@bonedancer3973]

I have a Powerflex 4 that came on a Jet Mill I purchased awhile back. Having difficulties with the torque settings and can't figure out how to increase motor torque. Does anyone know the setting to increase it? Like I'll drill a 1" hole in 1/8" steel and it constantly stops on me. I know the motor can handle a lot more than it's giving out but just can't figure out the setting for it. Any and all help would be appreciated.

[@RameshKumar-leeza]

Hi sir

[@nhaheiw]

Hope you can help on P031 my highest volts is only 230 but my motor is 380 v 3phase and I tested the single phase to 3Phase VFD and the outlet only gives me 230 v between phases. What can be wrong

[@juliocesardealmeida2167]

Dear sir!