2015 Ford Transit 250 ABS, Traction control, Hill start assist repair

แชร์
ฝัง
  • เผยแพร่เมื่อ 5 ก.ย. 2024
  • You can support Ukraine financially in war against Nazi Russia through these trusted foundations:
    United 24 u24.gov.ua/
    Serhiy Prytula Charity Foundation
    prytulafoundat...
    #tryityourself #doityourself #Ford #abs
    Become a member to get exclusive access to perks!
    / @vasylgladun
    Sensor Ford part number
    KK3Z-2C190-E

ความคิดเห็น • 68

  • @leethburn
    @leethburn 5 หลายเดือนก่อน +3

    this guy is very good ...very honest in his methods...

  • @fastedy123
    @fastedy123 ปีที่แล้ว +2

    I had the same problem on my 2018 transit. It affected my cruise control also. Cleaned and working perfectly. Thank you for your video. A++++++

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว

      Thank you for your comment.

    • @amish_h4ck3r
      @amish_h4ck3r หลายเดือนก่อน

      What did you clean it with? Contact cleaner?

  • @kjarby69
    @kjarby69 ปีที่แล้ว +1

    Your video was by far better than all the others on this problem!

  • @Roan65
    @Roan65 3 หลายเดือนก่อน +1

    brilliant video and many thanks

  • @raygarner923
    @raygarner923 ปีที่แล้ว +2

    Same warning lights on my 2014 Transit Connect. I’ll be under it tomorrow. Great call to investigate further before going back to the dealer.

  • @sergiupopa3811
    @sergiupopa3811 ปีที่แล้ว +1

    My man, I appreciate the video. Have same problem. I took the van to the shop they ran diagnostics and swapped sensors from one side to the other, bit that didn't fix anything. I had to pull the van out of the ship due to the next day scheduled job. They said bring it back and we will continue diagnostics at $110 an/h. I will be checking the wiring on that sensors and will be back to let you know. Seems like everyone has the same problem with left side. Let me know if anyone had experienced anything different. Thanks again.

  • @Da305Alive
    @Da305Alive 2 ปีที่แล้ว +6

    I have that light.i replace both rear sensor and still have dash lights on.glad you made the video,Il go back and chk the wiring.the van drove fine so i was just drive it with the annoying alert every start up.

    • @VasylGladun
      @VasylGladun  2 ปีที่แล้ว +1

      I hope you will locate the problem. Good luck.

    • @Da305Alive
      @Da305Alive 2 ปีที่แล้ว

      @@VasylGladun thks

    • @EverythingApax
      @EverythingApax ปีที่แล้ว

      @@Da305Alive did you find the issue?

    • @cliftongilbert7952
      @cliftongilbert7952 ปีที่แล้ว +1

      Could be the abs tuning ring

    • @cliftongilbert7952
      @cliftongilbert7952 ปีที่แล้ว

      Could be the abs tuning ring

  • @PedroZagada-n5y
    @PedroZagada-n5y หลายเดือนก่อน

    Thank you 👍

  • @pelochino1flores518
    @pelochino1flores518 2 ปีที่แล้ว +4

    Very good information I had the same problem and thanks to you I fix it my self thank you 🙏🏻

  • @unnitmetaliya3977
    @unnitmetaliya3977 หลายเดือนก่อน

    First off all great video bud. I was looking for my Ford Focus ABS sensor videos but found yours and watched fully as I enjoyed it. Few things though.
    1. Not everything is supposed to click. That was the plug and adapter you were wanting to hear the click from. Like you plug the phone charger in the wall plug and it doesn't click right? It was the same thing with that sensor plug.
    2. Always do step by step diagnosis. You realized the wire was faulty so soldered it and then went straight ahead to remove the new sensor and replace it with old one. What if the faulty wire and the original sensor both were the problems? Then you would have to replace the sensor again. Right? Always diagnose every step.
    3. It can be a rat who ate the wire lol. Just a guess. Haha.
    But great and honest video. The struggle was real. What a great way to save that 150$ imo.

  • @moonmunster
    @moonmunster ปีที่แล้ว +7

    Before you soldered the wire, you may have been able to put a small piece of heat shrink tubing on the wire, pushed it down out of the way while you soldered and then moved the tubing up over the solder joint and heat shrinked it.
    Great video. I have a 2016 Transit Connect and have had the exact same problem. In fact, I have it now. It is flakey. It works one minute and then you get the trouble lights about the ABS and hill assist start.
    The wire may have had rodent damage. Rodents are serious problems with vehicles. They need to stop putting soy in the wire insulation. This should be a class action lawsuit against all car manufacturers who use soy in wire insulation. Worst idea ever.

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว +2

      Totally agree about heat shrink, but at the time of the repair I didn't have any on hand, as you can see from the video I thought it was just an easy swap with a bad sensor.

  • @tomig2795
    @tomig2795 6 หลายเดือนก่อน +1

    Thank you😊

  • @RafaelFerreiraffael
    @RafaelFerreiraffael 2 ปีที่แล้ว +1

    Good job man. Thanks for the video, seems easy enough to repair

    • @VasylGladun
      @VasylGladun  2 ปีที่แล้ว

      Little bit tricky because of the location but not too bad. Thank you for the comment.

  • @ivobiancucci4528
    @ivobiancucci4528 2 ปีที่แล้ว +3

    Very informative great content

  • @fatfill520
    @fatfill520 ปีที่แล้ว +1

    Pleased ive watched this I will give it a try thanks

  • @kristianf8840
    @kristianf8840 ปีที่แล้ว +1

    Thx it worked for me really easy

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว

      Thank you for the feedback.

  • @DJVetz510
    @DJVetz510 ปีที่แล้ว

    I had these lights come out too. All i did was push the switch under the dashboard all the way with my finger. This switch is on driver side, and the brake handle pushes on it when the foot brake is in normal resting position.

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว +1

      I don't think this would work in my case with the cut wire.

    • @Monotone1118
      @Monotone1118 ปีที่แล้ว

      What switch, I can’t seem to find it

    • @DJVetz510
      @DJVetz510 ปีที่แล้ว

      @@Monotone1118follow the brake lever up to the under part of the dashboard. Youll see a push-in/out switch

  • @palasunar24
    @palasunar24 ปีที่แล้ว +1

    Thanks for your video it is real halp full a++++❤

  • @wwrrr4289
    @wwrrr4289 ปีที่แล้ว +1

    Nice

  • @catfish24
    @catfish24 ปีที่แล้ว

    I have a 2015 Ford Transit 150 cargo van with only 53000 miles on it it's been babyed since i bought it new and now I have a warning light coming on that says ABS BRAKE POWER BOOSTER FAILURE SERVICE IMMEDIATELY and when I push the brake pedal its hard to push and the van doesn't want to stop like it should. Taking it to the Ford dealership Monday.

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว +1

      If you don't mind, can you please share the results after visit to Ford dealership

    • @catfish24
      @catfish24 ปีที่แล้ว

      @@VasylGladun ok

  • @HerringMotorsports
    @HerringMotorsports 8 หลายเดือนก่อน

    over a half million miles? wow

  • @jerry2lalito
    @jerry2lalito 2 ปีที่แล้ว

    Good work amigo

  • @marydowns7118
    @marydowns7118 ปีที่แล้ว

    Thank you for this video!

  • @mizaelbautista6151
    @mizaelbautista6151 ปีที่แล้ว

    help where is parking aid sensor located on 2015 ford transit connect?

  • @johnnyz.fradley2306
    @johnnyz.fradley2306 4 หลายเดือนก่อน

    Mouse chew through wire. What's the name of the sensor?

  • @casamorag
    @casamorag 7 หลายเดือนก่อน

    👍

  • @ccilogu
    @ccilogu 3 หลายเดือนก่อน

    What is the Ford part number for that new sensor you installed?

    • @VasylGladun
      @VasylGladun  3 หลายเดือนก่อน

      In description

    • @ccilogu
      @ccilogu 3 หลายเดือนก่อน +1

      Thank you, sir.

  • @Ranglin1975
    @Ranglin1975 ปีที่แล้ว

    Would a bad wheel speed sensor cause abs pump to run continuously killing my battery?

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว

      Looks like I've learned something new today, I never heard about it before, but according to Google is possible

  • @tatianasantos7858
    @tatianasantos7858 ปีที่แล้ว

    How do I know which one I have to repair ??

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว +2

      In my case it was easier because right before the repair I had my van diagnosed at Ford dealership. In your case, you have two options, the cheaper one visually inspect all wires on all four ABS sensors, if you don't see anything, go to plan b which is buying one ABS sensor and replacing on every position until you hit the broken one.

  • @embeastn_plays6925
    @embeastn_plays6925 ปีที่แล้ว

    Which OBD code was firing?

    • @VasylGladun
      @VasylGladun  ปีที่แล้ว

      I didn't check the codes on this one since Ford pointed out a faulty sensor for me.

  • @ilirleka5602
    @ilirleka5602 8 หลายเดือนก่อน

    How do i know witch sensor it's not working??

    • @VasylGladun
      @VasylGladun  8 หลายเดือนก่อน +1

      I don't think you can find out without special diagnostic tool.

  • @olidubic
    @olidubic 8 หลายเดือนก่อน

    Do you have the sensor part number by any chance . Thanks

    • @VasylGladun
      @VasylGladun  8 หลายเดือนก่อน

      KK3Z-2C190-E

    • @olidubic
      @olidubic 8 หลายเดือนก่อน

      Thanks but my problem come from the Tone Wheel on the rear right side . Did you ever had this problem ? @@VasylGladun

    • @VasylGladun
      @VasylGladun  8 หลายเดือนก่อน

      No, I didn't have that problem.

  • @richardwells3808
    @richardwells3808 ปีที่แล้ว

    {