Thanks for the video. Was having an issue with a 2003 ZX6R not starting. It would crank but had no spark. Added a resistor to the gray wire and it started right up.
How can I find which wires are for my blinkers ? It’s been cut before for different blinkers and I want some on it now and don’t know how to find the blinker wires
Sorry, I need to get better at seeing comments on here. I believe the front right positive is grey and front left is green. The negatives should be black/yellow or just black. Use a test light or a multi-meter to verify with the signal switch on.
Thanks for the video. Was having an issue with a 2003 ZX6R not starting. It would crank but had no spark. Added a resistor to the gray wire and it started right up.
What voltage is the grey wire supposed to have I’m getting 9 to 9.5 is that to much
Simple, was looking for this thanks
My bike fired right up. I was almost about to buy an ECU lol
Is it the red and gray that the resister goes in between?
I doubt it actually runs. I got the same problem but the immobilizer won't allow it to run. It'll crank but it won't run.
Mine runs fine with this setup.
How can I find which wires are for my blinkers ? It’s been cut before for different blinkers and I want some on it now and don’t know how to find the blinker wires
Sorry, I need to get better at seeing comments on here.
I believe the front right positive is grey and front left is green. The negatives should be black/yellow or just black. Use a test light or a multi-meter to verify with the signal switch on.
It's a 1/2 Watt 100 Ohm....
It I just use. The switch how to do it and tip over sensor lost how. Can I do it with out the part and. I do the same e thing with the restor
Can you dumb down your wiring diagram I’m medically diagnosed dyslexic so that made zero sense😂
Hello are you available for questions