I added a Jandy Ei Aquapure to my system following the directions and with your expert guidance. I do not know where to connect the 4 wire connector to in my RS8 Pool panel, No SPA. The top 2 sections on the board are taken, one for the Heater (Jandy Heat Pump), and the other for the variable speed pump. Where can I connect the Chlorinator?
Thanks John. Question, my truclear system keeps turning on and off. In phoenix its still to cold for salt system to be in service. But the system keeps powering on and cycles off, then on, every 6 seconds or so with pump running in auto. Should it stay on in standby or say lowtemp/ low salt? Thanks. Just got new 2.7 flopro replaced, exact same pump, same wiring, not sure why this is happening
It should say lowtemp/lowsalt if the water is below 50 and the unit is powered on. Standby is just off for all intents and purposes. I would leave it in standby until the water warms up.
@@JohnThePoolExpertGuy so when my pump turns on, it says chlorinating, then standby, then it shuts off. Screen goes dark. Then back on again to chlorinating.. it cycles like this all day. It should stay on in standby. Not sure why it changed or cycles on and off
@@JohnThePoolExpertGuy so if you hold power button down for 6 seconds the unit supposed to shut off. Well mine powers itself back up a few seconds later. Hmmm
![เปิดใจ พี่ญา คนรุม หลังทัวร์ลง หนักสุดในชีวิต!! l [Nickynachat]](http://i.ytimg.com/vi/2-OJZRtclro/mqdefault.jpg)
I have the Aquapure working fine. Is there a way to add it to my home screen. I do not have any choice for that. You have been very helpful!
I added a Jandy Ei Aquapure to my system following the directions and with your expert guidance. I do not know where to connect the 4 wire connector to in my RS8 Pool panel, No SPA. The top 2 sections on the board are taken, one for the Heater (Jandy Heat Pump), and the other for the variable speed pump. Where can I connect the Chlorinator?
you have to double up the wires on one of the comport 4wire connections
Thanks for your reply.
Thanks John. Question, my truclear system keeps turning on and off. In phoenix its still to cold for salt system to be in service. But the system keeps powering on and cycles off, then on, every 6 seconds or so with pump running in auto. Should it stay on in standby or say lowtemp/ low salt? Thanks. Just got new 2.7 flopro replaced, exact same pump, same wiring, not sure why this is happening
It should say lowtemp/lowsalt if the water is below 50 and the unit is powered on. Standby is just off for all intents and purposes. I would leave it in standby until the water warms up.
@@JohnThePoolExpertGuy so when my pump turns on, it says chlorinating, then standby, then it shuts off. Screen goes dark. Then back on again to chlorinating.. it cycles like this all day. It should stay on in standby. Not sure why it changed or cycles on and off
@@JohnThePoolExpertGuy so if you hold power button down for 6 seconds the unit supposed to shut off. Well mine powers itself back up a few seconds later. Hmmm
How much do installs like this cost?
Depending on where you live it can cost between $200 and $600 for labor plus materials.
I don't believe you can on an RS. I think you will have to go into the Menu to get to it.