Temperature Control using Arduino with WinCC SCADA via Modbus TCP

Temperature Control using Arduino with WinCC SCADA via Modbus TCP/IP
: In this video Liquid temperature controlling using Arduino UNO with WinCC SCADA over Modbus TCP/IP communication protocol have been shown.
This is a step by step tutorial video for developing and implementing a project for controlling liquid temperature from PC based SCADA interface using Arduino UNO Micro Controller and WinCC SCADA software. The aim of this video is to show technique for how a Arduino UNO micro controller can be interfaced with Siemens PLC SCADA software using Modbus TCP/IP communication protocol to develop Arduino based SCADA project. A real time temperature control operation can be performed using this Arduino based scada project.
Equipment & Software List:
1. Arduino UNO board
2. Ethernet Shield W5100
3. LM 35 Temperature Sensor
3. Peltier Heating Module
4. Arduino IDE for Arduino programming
5. SCADA Software: WinCC integrated in TIA Portal
6. 5 Volt Relay
7. Transistor BD135 &
8. Other components shown in schematic diagram
Download Link for Project Contents:
drive.google.com/drive/folder...
Music: Bensound

[@kamugishajoseph6467]

thanks for the nice video

[@TechTutorial20]

Thank you so much....best of luck

[@georgemugala4830]

Good work

[@TechTutorial20]

Thanks

[@MetaforaReborn]

apakah dapat diterapkan pada software scada yang berbeda?

[@thienluongminh3229]

Hi, I have test on my arduino but when I connected to a device the Arduino hangs, cannot to ping to the ethernet shield board. Do you know how to fix this problem?

[@TechTutorial20]

Please check IP address and subnet mask for both Arduino and the device(pc) connected to arduino.

[@thienluongminh3229]

@@TechTutorial20 Yes, I configured and ping ok but when I connected to a device the Arduino hangs, cannot to ping continue to the ethernet shield board.
When I reset the board, the same thing happens again.

[@TechTutorial20]

Please send me the Arduino sketch to my email address. My email: [e-mail]
Mention your pc IP address and subnet mask.

[@thienluongminh3229]

@@TechTutorial20 I sent you an email, please check it for details. Thanks

[@hashirimran7682]

can i get the arduino code youre using

[@kkokemaki8593]

I suppose you did not use WinCC *SCADA* (WinCC Professional), you just used the less complex WinCC Advanced

[@TechTutorial20]

I have used WinCC SCADA advanced. But I think it is possible with WinCC professional. Thanks a lot..

[@KarthikVijai-hl7ws]

bro is it possible with NodeMCU ESP 8266

[@TechTutorial20]

This is possible with NodeMCU ESP 8266. You have to use any modbus tcp/ip supported scada software.

[@KarthikVijai-hl7ws]

@@TechTutorial20 bro i am beginner i followed yoy...can u guide me bro... i want to do with tcp/ip nodemcu and scada

[@TechTutorial20]

Thank you for your interest. you can follow this video th-cam.com/video/tChSSNOTRGc/w-d-xo.html

[@MsBahget]

download link isnot working

[@TechTutorial20]

Now you can try the download link....thanks for your information

[@user-ox1gn4is1j]

😂

[@user-ox1gn4is1j]

Explain one by one all 😂