Calculating 45 Degree Parallel Offset

แชร์
ฝัง
  • เผยแพร่เมื่อ 22 พ.ย. 2024

ความคิดเห็น • 12

  • @joshlaws1592
    @joshlaws1592 4 หลายเดือนก่อน

    Great video! Thanks for the information

  • @robjohnston5292
    @robjohnston5292 7 หลายเดือนก่อน

    I can't think of any reason I will need to calculate anything like this. I watched the video simply for the joy of learning. I understood it right up until 9:19 when it comes to calculating the length of B,E,H. Where do you get the "Offset" number? The term offset is used throughout the video, but i don't think it's defined. Also, right in the last few seconds you introduce the term "Advance" without defining it. It appears these videos are too supplement what you taught during an in- class lecture, so perhaps your target audience is already supposed to know those terms.
    I've been enjoying your series of videos. I landed here because I'm redoing plumbing that a "handyman" did during a bathroom remodel. There's a veritable plethora of code violations from horizontal hard 90° turns, Sani-Tees lying on their back, and S-traps under the sink and tub. Good times.

  • @ryanthefox4889
    @ryanthefox4889 ปีที่แล้ว +2

    Painful

  • @dominiquepierre916
    @dominiquepierre916 3 ปีที่แล้ว +1

    I read book I understood but your video i just got confused

    • @edwardlogan5428
      @edwardlogan5428  3 ปีที่แล้ว +1

      Which book did you read and was it good?

    • @dominiquepierre916
      @dominiquepierre916 3 ปีที่แล้ว +1

      @@edwardlogan5428
      I apologize for my comment
      You are great teacher and please continue your videos .
      I love your videos .
      Just I need to improve my basic knowledge in math

  • @leonwoods4052
    @leonwoods4052 2 ปีที่แล้ว +2

    DUDE WHERE IS THE CALCULATIONS? DID YOU MAKE THIS VIDEO TO HEAR YOURSELF TALK?. WHAT KIND OF TEACHING IS THIS ?

    • @edwardlogan5428
      @edwardlogan5428  2 ปีที่แล้ว +1

      Thank you for your comment. Sorry to hear you didn't find the video useful.

  • @dominiquepierre916
    @dominiquepierre916 3 ปีที่แล้ว +1

    First explain what is spread ,what is spread allowance ,where is k ;where is x;
    You just read ;
    This is not teaching !
    To be honest I did not understand your video
    This is not teaching 😁

    • @edwardlogan5428
      @edwardlogan5428  3 ปีที่แล้ว +2

      K is explained as the spread between between D & G (Centre to centre measurement) and X is the variable that comes from the table. Thank you for your comment.

    • @dominiquepierre916
      @dominiquepierre916 3 ปีที่แล้ว +1

      I studied plumbing apprentice book
      I appologize for my comment.
      I got it .

  • @ifaifa982
    @ifaifa982 11 หลายเดือนก่อน

    👎👎👎 I boo your video sir