If you guys make these videos you should make sure you explain that this is for the 2.4L, not the V6. They are completely different. Only the 2.4L have them under the car, while the V6 are all in the engine bay.
I always spray the O2 sensor where it goes into the cat with a penetrating oil like WD40 before breaking the old O2 sensor loose. And I do believe you will have to clear any codes that old sensor may have set in order to not have a "check engine" light after replacement.
The NTK brand o2 sensor is a perfect fit with all new clips. On my 2 door accord the wire comes up through the floor a little farther forward and it helps to unbolt the seat and lay it back a little bit.
I have to replace mine and this is what I thought was going to have to be needed I'm going to make my life simpler... Not that I would do this on a customers car... I'm going to cut those three wires . And solder them on to the new one
√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
If you guys make these videos you should make sure you explain that this is for the 2.4L, not the V6. They are completely different. Only the 2.4L have them under the car, while the V6 are all in the engine bay.
Great video! Everything was well lit and very easy to understand and follow. Thanks!
Very good video with step by step instructions. The best is changing both o2 sensors same time.
Thank you I needed this video. I do a lot of simple repairs to my car myself. This was explained very well.
Excellent tutorial.. thank you so much
Great video. I am assuming this is for the 4 cylinder model?
I always spray the O2 sensor where it goes into the cat with a penetrating oil like WD40 before breaking the old O2 sensor loose. And I do believe you will have to clear any codes that old sensor may have set in order to not have a "check engine" light after replacement.
Just screw the sensor in first, then plug the connector, that way no need to worry about twist wires...
Is the same for a 3.0 ? Same sensor for 2.4
The NTK brand o2 sensor is a perfect fit with all new clips. On my 2 door accord the wire comes up through the floor a little farther forward and it helps to unbolt the seat and lay it back a little bit.
Made that look easy! Thanks😊
Fantastic job on the video, I am grateful. It made the job super easy.
what size socket you used to unthread O2 SENSOR ?
what’s the part number for the O2 sensor wire bracket?
What was the reason the downstream oxygen sensor needed to be changed? Was it throwing a code?
⭐⭐⭐⭐⭐ Es una excelente explicación Muchas gracias por este video
P0139 HO2S S2 Circuit slow Response what does it mean? Which sensor has to be replaced (Honda Accord 2005 4cyl/2.4
The wiring harness won’t separate while pressing tab
I just tighten up till snug not a certain foot pounds . Works just fine
Great video! That seal is a mf and the carpet everything easy as 123
awesome ty
Why don’t you screw the o2 sensor in before clipping the wire in so you don’t have to twist the wires and mess with their integrity.!!
O2 bank 1 s2
What if your catalytic converter was taken out ?
Please do a video on how to replace the shift solenoids
My light still on after putting new one. Isubbed
I have to replace mine and this is what I thought was going to have to be needed I'm going to make my life simpler... Not that I would do this on a customers car... I'm going to cut those three wires . And solder them on to the new one