1HZ Belt Timing & Injection Pump Timing

แชร์
ฝัง
  • เผยแพร่เมื่อ 22 ต.ค. 2024

ความคิดเห็น • 9

  • @digitalbilly
    @digitalbilly 4 หลายเดือนก่อน

    thanks for the video. i have sent my pump away for rebuild and i now have all the tools and the knowledge to do the job right!!!!

  • @gman4reel
    @gman4reel 10 หลายเดือนก่อน +1

    Glad I found this ... All the other videos showed the other marks.... wow ... I am about to replace my injector pump.

  • @lalabash2828
    @lalabash2828 ปีที่แล้ว +3

    Rideo good luck with it cheers mate we needed that

  • @mbsoldschool
    @mbsoldschool ปีที่แล้ว +1

    Mate just querying your spec for injection timing. I have these figures. Landcruiser 75/80 series 1.03 - 1.09mm @ TDC, 100 series .85-.91mm @ TDC. Toyota Coaster 2000 is .65-.71mm @ TDC w/- ACSD and .85-.91 @ TDC w/out ACSD. I have a 2000 Coaster which I am about to check. I just had the timing done by a diesel mechanic a few months ago but don't know what he set it to so about to find out. The bloody engine started to missfire not long afterwards, now blows out shitloads of white smoke after 1200rpm to about 3000rpm, misses its arse off while this is happening but comes good under more throttle. So I will check it to see if this is the problem.

    • @mbsoldschool
      @mbsoldschool ปีที่แล้ว

      @@jaffasoft8976 I bought a workshop manual disc on E-bay that had all sorts of info on several models with different engines. The disc did not work as intended so I used file manager & went through the entire discs folders & found the pages related to any service data. Interesting though that a 2000 model Landcruiser with the same engine has the spec of 1.09mm but the coaster is less. Mine has the ACSD so I guess it should be .65-.71mm according to the service data. One thing I am not certain on is whether the spec is for australian model coaster. For all I know it could be for european models? Had a good look under the bus today & the marks on the housing lines up with the mark on casing, so it must be close. I have yet to figure out how the hell I am going to get the dial gauge into position to check the setting, as you know room is limited. I can't drive it as it is atm, if the timing is correct then I may have other serious issues. where have you seen the china knock off pumps & injectors?

  • @agostinhojose3120
    @agostinhojose3120 6 หลายเดือนก่อน

    Gostei

  • @kotasonamtenzin
    @kotasonamtenzin ปีที่แล้ว +1

    Great video. One question. What about the factory mark on the pump and the housing ? Shouldn’t that marks align?

    • @ForPropertyInvestors
      @ForPropertyInvestors  ปีที่แล้ว +1

      That is correct. Though that can be adjusted a bit to sometimes. The new pump I bought didn’t have any makes. Its about the centre on my old factory one.

  • @pl1311
    @pl1311 8 หลายเดือนก่อน

    I don’t suppose this applies to the later 2007 onward 1hz. The FSM states TDC.