Blackhorse l-39 turbine update number 2

[@McGyverPilot]

A bit late now but next project consider painting all the inside paneling the traditional olive green for the authentic look.

[@TomislavReskovic]

in your last video, you noticed pipe was a bit low, so you will put shims under, here in @6:00 ... plase try to rotate pipe so pipe seam is not down but up, that will prevent smoke oil from dripping inside, since it is not a watertight seam, only spot welds, and since bell mouth has 2 holders (L brackets) that are not dead center, maybe you will also raise the pipe a bit so no shims will be needed. try it and you will see. I have same pipe in BH viper + K102. cheers and happy maiden.

[@ghoustanable]

Too funny I noticed that when I was putting the shims in, I will definitely get that rotated much appreciated.

[@rockfordtractor]

Can you post the dimensions of the engine mount area so I can see if my engine might fit? The width between the bearers and the width across the top of the mount (where you had to cut your engine mount to fit) would be helpful. Thanks...

[@ghoustanable]

The turbine inside rails is 4 and a quarter inches wide.

[@rockfordtractor]

@@ghoustanable Thanks!

[@eoinj3929]

Can you provide a link to the supplier of the black heat shield tubing ? Thanks and interesting build. 👍

[@ghoustanable]

Heat Hose Fiberglass Wrap Shield Sleeve Wire Fuel Line Heat Shield Roll High Temp up to 1100° F Black Colour Adjustable 10FT-13MM(1/2") for Car Wire Loom Protection a.co/d/9lmvhQA