Would love to have the knowledge & experience these guys possess. A fully reconditioned Toyota V8 diesel, like this one, can sell for as much as $40k in Australia.
I am writing from Türkiye. I own a Toyota Corolla 2010 D-4D and I love my car very much. I have not had any problems for 4 years. Toyota makes the healthiest engine in the world. my opinion
Ремон выглядит красиво но они поставили обратно старую звездочку фазовращателя которая на половину стертуую, в последствии чего приведет к дорогостоящему ремонту двигателя.
Absolutely lovely. God bless you guys and your families. This kind of dedication has taken Japan 🇯🇵 where you guys have gone after the catastrophe of Hitoshi & Nagasaki. Lots of love and good wishes from Bengaluru 🇮🇳
Que fue clave en este trabajo los gatos hidráulicos y levantados eléctricos, ya de último la mano de obra sin mencionar las pistolas de impacto eléctricas pero bueno excelente trabajo
This can't be some warranty work, this has to be a very rich person that WANTS that done. That job alone, on most cars would be in the $10s to $20,000 range, most cant afford that as just "maintenance". Awesome work though.
Я не понял, а зачем заводские гильзы вырезали? Весь ресурс двигателя заложен в их износостойкости. Не думаю что с новыми гильзами он будет долго работать.
Помоему коленвал задраный оставили, не шлифанули посадочные места и гильзы както жестко забили , не знаю ьерзают смутные сомнения на счет качества ремонта
I would like to know why they're putting sleeves into the block and cutting new valve seats? I didn't see any issues with the cross hatch or any damage to the heads to warrant that job.
True mechanic.. in my state, not many mechanic do the right work when they do their job..they too lazy.. just thinking about money.. and the results of the is worst.. i dont trust them anymore.. that's why many people DIY to theirs own car... Me also...
Тем же говном, из которого сделали масло, на котором этот двс работал. Такие залаченные движки только от херового масла и редкой замены. Жмотистый китаец ездил.
Thers a quality for their work... cause unlike America.. they get paid houly... they take their time & does it right. not flat rate per job...so tech takes every short cuts cleans nothing makesure everthing stays ok for just few months until labour warranty is over.
Vida longa pra essa Toyota. Parabéns aos profissionais que belo trabalho.👏👏👏
Великолепная работа. Жму вам руку🤝
Привет от электрика, который тоже кайфует от своей работы.
These guys must geniusly know about the engine inside out..👏👏👏
Assembly and repair, yes. As for design, the engineers win on that front.
I am very impressed with your work, it is very neat and clean.
Thank you very much!
Blessings to you and the family, all the way from jamaica 🇯🇲much respects 🍾💯
Красивая работа механиков! 👍👏 Perfekto!
Хоеного, как стукал гильзы 😂
I feel confident that these guys are really good ethical mechanics.
Never touched a torque wrench. This is a hack job.
@@kmacs9905they did... everything ain't torqued
@@kmacs9905you can see them multiple times using a torque wrench wth are you on about
@@Debergaizen
Drugs.
3:17
Imagine after you join back the engine , you notice some extra parts still left over😂
That happened to me
the first time I rebuilt
a four-barrel
carburetor ! 👈🤪
I was just thinking something similar... like a leak somewhere on the head
It’s not a BMW
Put on pocket😂😂😂 then throw
Thank you for this Tutorial. Will do it tomorrow
When a robot can do such an overhaul to a variety of ICEs wake me up.
Amazing work gentleman.! 👏👏 👏
Bisa rapi seperti baru dari pabriknya
Keren
Sukses selalu buat yang punya channel
Всё не бит, не крашена, ездила бабушка 😂😂😂😅
What a informative video
Talented and skill3d mechanics
Emang bagus sih, ini baru oke banget... Keren pekerjaannya. Bersih daleman mesin nya. Wajar kalo mahal biayanya
Would love to have the knowledge & experience these guys possess. A fully reconditioned Toyota V8 diesel, like this one, can sell for as much as $40k in Australia.
Does Toyota have a V8 Diesel?
This is a gas engine
@@abdul-kabiralegbe5660yes they do have a V8 diesel.
LC200 дизель V8 4.5 l
Whoa!
Как говорится "ежели один человек собрал, другой завсегда расхерачить сможет".
I am writing from Türkiye. I own a Toyota Corolla 2010 D-4D and I love my car very much. I have not had any problems for 4 years. Toyota makes the healthiest engine in the world. my opinion
Beautiful job!!!
гильзы забили хоть не с одного удара😂 у нас так даже в гаражах не ремонтируют
У нас бы демиксидом отмыли и дальше ездили,или расточили бы в 0.5 на тейкин и тоже бы ездили норм
Nice, did not see grease go on upper cam shaft U clamp- like you did lower ones. But was fast video so maybe did it and didn't show. Nice video.
Ремон выглядит красиво но они поставили обратно старую звездочку фазовращателя которая на половину стертуую, в последствии чего приведет к дорогостоящему ремонту двигателя.
Дружная команда, молодцы!
Love the videos ❤
После запуска будет стучать, муфты VVT не зарядили.
Excelentemente excelente!
🙏🏻🙏🏻
This is a "while it's taken apart I should just upgrade this part" rabbit hole
We need mechanics like them here
Absolutely lovely. God bless you guys and your families. This kind of dedication has taken Japan 🇯🇵 where you guys have gone after the catastrophe of Hitoshi & Nagasaki. Lots of love and good wishes from Bengaluru 🇮🇳
Да, далеко наверное он на такой гильзовке уедет))))
Почему
у 200х форсунки льют,потом пи(') зда двиглу! Троих лично знаю
Так эт ж наши друзья😂,тыщ 20-30 пройдёт после этого и норм 😊
Ну,до дома доедет)
Вы в принципе про гильзовку? Я на спортаже3 сделал гильзовку 70ткм назад, полёт нормальный.
Que fue clave en este trabajo los gatos hidráulicos y levantados eléctricos, ya de último la mano de obra sin mencionar las pistolas de impacto eléctricas pero bueno excelente trabajo
I will be doing this to my Toyota tomorrow.
This can't be some warranty work, this has to be a very rich person that WANTS that done. That job alone, on most cars would be in the $10s to $20,000 range, most cant afford that as just "maintenance". Awesome work though.
Sensacional !!!
Если есть ремонтные поршня то лучше их поставить , гильзовка меньше ходит.
Совершенно верно+++++
Да им там неважно, они и такую работу продадут
Конечно!тейкины есть +0.5! Только зазор надо побольше под них делать.
Que trampo!!! 😎👍🏻⭐⭐⭐⭐⭐
Very nice car, simple and repairable.
Всё понятно👌 Завтра переберу
На вскидку жесть сборочка. Гильзуют плохо, собирают плохо. Интересно сколько проедет.
สุดยอดครับ💗💝💖👍👌
Meanwhile, in Europe:
"You blow the headgasket? Out of warranty? Buy whole new engine, It isn't cost efficient to drop the head on your 2.0 4 pot."
I hope that washdown water is heading to an interceptor for treatment before disposal
Why would you care?
But I only asked for a rear light bulb replacement!
Чем прокладку гбц намазали?
Как работает передняя крышка грм если головки и цилиндры фрезеровали и их высота немного изменилась, крышка цельная
Maravilloso❤❤
😍😍 wow. That was beautiful
Боюсь эта работа с запчастями стоит дороже нового автомобиля
Какая красота🤩🤩🤩
Competentíssima oficina vou levar minha Brasília ano 76 Pará revisão.
I've never seen this machine treatment in Indonesia. If you could show me where it is located, that would be great.
Я не понял, а зачем заводские гильзы вырезали? Весь ресурс двигателя заложен в их износостойкости. Не думаю что с новыми гильзами он будет долго работать.
Конечно
В него подсолнечное масло что-ли заливали?
Что они вставили в рубашку охлаждения цпг 😮 и чем и зачем намазала прокладку гбц?
Hola Mía. Buen trabajo. Saludos 🌹.
Помоему коленвал задраный оставили, не шлифанули посадочные места и гильзы както жестко забили , не знаю ьерзают смутные сомнения на счет качества ремонта
Можно было димексидом отмыть и раскоксовать,ни чего не разбирая
I can almost smell the stench of that burnt oil.
Its ready for another 1mill KMs 🎉🎉
Класс !!! 😊
интересно, на сколько они сократили ресурс этого ленд крузера, собрав движок голыми руками?
Что ты несешь ?🤦♂️
One new rebuild, 500 fish killed from toxic runoff....
Красота
No plastigage on the main bearings?
It's cheaper to change the oil in time or even more often than doing a complete engine out overhaul people.
Just beautyful...
2UZ FE отличный мотор, впрочем как и всё от TOYOTA!
Это UR FE грм цепной. У UZ FE ременной.
И блоки разные 😂
Скучное и унылое с минимальным инженерным расчетом , как и все японское.
@@user-cu4tm3xl9z продажи с тобой далеко не согласны ...
@@user-gu4ru2xu9f продажи не согласны и лохи которые эти продажи создают тоже.
Good
Wish they would do this to my '12 Tundra Crewmax...
I would like to know why they're putting sleeves into the block and cutting new valve seats? I didn't see any issues with the cross hatch or any damage to the heads to warrant that job.
Потому что руки из ass
У меня тоже Тойота Прадо вот мне бы также машину так же профилактику сделали
Дак сам сделай
i wanna go work with these guys
Très bien
True mechanic.. in my state, not many mechanic do the right work when they do their job..they too lazy.. just thinking about money.. and the results of the is worst.. i dont trust them anymore.. that's why many people DIY to theirs own car... Me also...
Моя нива нервно курит в сторонке:)
да? А вот моя меня исправно возит по рыбалкам-охотам с 2017 года)
What is the liner thing at 3:52 ?
My favourite work
Perfeito
Now THAT's what I call a CAR WASH!!!
In the U.K. this job would cost more than buying a replacement Land Cruiser.
100/100
Какой пробег?
3UR. Сильный и надёжный двигатель. Что с ним делали, чтобы уложить???
Эксплуатировать
@@megadron4039 работаю в сельском хозяйстве. Масса фермеров ездит на LX, Tundra и TLC200. Пробеги уже далеко за 500. И живые.
Можно было димексидом отмыть
Respect Mia
А куда у них вся эта жижа стекает интересно ?😮
Ну парни сейчас разберут все, изучат и лучше сделают!)
I need my ecodiesel rebuilt by them
Чем вы намазываете прокладку ГБЦ ?
Тем же говном, из которого сделали масло, на котором этот двс работал. Такие залаченные движки только от херового масла и редкой замены. Жмотистый китаец ездил.
Звезды VVTI даже не помыли.)))
Thers a quality for their work... cause unlike America.. they get paid houly... they take their time & does it right.
not flat rate per job...so tech takes every short cuts cleans nothing makesure everthing stays ok for just few months until labour warranty is over.
Milage info would be nice
They did it for fun, no way it _needed_ overhauling......
Как полмашины стоимость этой процедуры😂
Конечно 😂легче новую машину купить
А фазики поменять? Цепи недолго проходят
Тоже не понял почему сэкономили на замене фазиков
Not one speck of rust on that frame.
В России даже на заводе так капиталку не делают
Гильзы кувалдой не забивают
Молодцы! Быстро так!🤣
Покажите это учебное пособие рукожопам с газоведерного завода!
Ебать гильзу забивают молотком.... это что вообще такое??? Разве не в озоне держат а после вставляют
азот
Which engine parts washing cleaning agents of name